Panasonic WJ-MP204 Operating Instructions Manual

Also see for WJMP204 - MULTIPLEX UNIT: Operating instructions

18 System Setup for CameraCommunication Mode1. Display the Setup menu.2. Move the cursor to SYSTEM by pressing button 1 (C)or button 2 (D), then press the SUSPEND/SET button.• In case of Camera Communication mode, the SYS-TEM menu appears as shown below.SYSTEMALARM MODE ONCOMP/VD2/DATAVS/VD INPUT VDDAISY MODE ONTERMINAL ALARM3. Move the cursor to the desired item by pressing button1 (C) or button 2 (D), and then select the desiredmode by pressing button 3 (–) or button 4 (+).4. Press the SUSPEND/SET button.5. After taking the above steps, press the SETUP/ESCbutton for 2 seconds or more.Note: All the settings must be compatible with theperipherals connected.(1) Alarm Mode Setting• Monitor Spot Setting1. Display the SYSTEM menu.2. Move the cursor to ALARM MODE by pressing button 1(C) or button 2 (D), press the SUSPEND/SET button,then select MONITOR SPOT ON or OFF by pressingbutton 3 (–) or button 4 (+).The initial factory setting is ON.ON: The screen of the corresponding channel appearson the spot output screen when the alarm is activat-ed.OFF: The screen continues to display the pictures inthe mode selected previously when the alarm isactivated.• Alarm Display Setting1. Display the SYSTEM menu.2. Move the cursor to ALARM DISPLAY by pressing button1 (C) or button 2 (D), then select ALARM DISPLAY ONor OFF by pressing button 3 (–) or button 4 (+) so that[ALARM∗∗∗] appears on the screen or not.The initial factory setting is ON.Note: The figure shown in the place of [∗∗∗] after theword ALARM is a channel number.• Site Alarm Setting1. Display the SYSTEM menu.2. Move the cursor to SITE ALARM by pressing button 1(C) or button 2 (D), then select SITE ALARM ON orOFF by pressing button 3 (–) or button 4 (+).The initial factory setting is ON.• Terminal Alarm Setting1. Display the SYSTEM menu.2. Move the cursor to TERM. ALARM by pressing button 1(C) or button 2 (D), then select TERM. ALARM ON orOFF by pressing button 3 (–) or button 4 (+).The initial factory setting is ON.• Alarm Output Data (Alarm Output Duration fromAlarm Connector)1. Display the SYSTEM menu.2. Move the cursor to ALARM OUTPUT by pressing button1 (C) or button 2 (D), then select the desired alarmoutput duration, 1S - 30S, 40S, 50S, 1MIN, 2MIN, 3MIN,4MIN, 5MIN, EXT or OFF, by pressing button 3 (–) orbutton 4 (+).The initial factory setting is 10S. Enable to set by 1 sec-ond (1S - 30S).EXT: The alarm signal continues to be output fromALARM/REMOTE connector till the alarm isreset. The alarm is not automatically reset.1S-5MIN: The alarm signal is supplied from ALARM/REMOTE connector only for the set time. Thealarm is automatically reset after the set time.(The ALARM indicator changes from blink tosteady light.)OFF: The alarm signal is not supplied from ALARM/REMOTE connector. The alarm is not auto-matically reset.ALARM MODEMONITOR SPOT ONALARM DISPLAY ONSITE ALARM ONTERM.ALARM ONALARM OUTPUT 10SALARM DATA AUTO2