Panasonic WJ-MP204C Operating Instructions Manual

Also see for WJMP204C - DATA MULTIPLEX UNIT: Product catalog Operating instructions

Panasonic WJ-MP204C Operating Instructions Manual Manual pdf 25 page image

258 CAM ADDRESSCamera addresses are assigned to each of the unit's cam-era input.1. Move the cursor to CAM ADDRESS , then pressSET. The CAM ADDRESS window appears.2. Specify a number with the [–] or [+] button. The defaultsetting is 1.Available numbers: 1-99, – (no assignment)Note: This setting takes effect only when the UNITswitch is set to 0 on the front panel.3. Repeat the above step until all camera inputs are givenaddresses.4. Press ESC to return to the communication setup.8 BAUD RATE1. Move the cursor to BAUD RATE, then specify a ratewith the [–] or [+] button. The default setting is 19 200.Available rates (bit per second): 19 200, 9 600,4 800, 2 4008 DATA BIT1. Move the cursor to DATA BIT, then specify a bit lengthwith the [–] or [+] button. The default setting is 8.Available bit length: 7, 88 PARITY1. Move the cursor to PARITY, then specify a check modewith the [–] or [+] button. The default setting is NONE.Available check modes: NONE, EVEN, ODD8 STOP BIT1. Move the cursor to STOP BIT, then specify a bit lengthwith the [–] or [+] button. The default setting is 1.Available bit length: 1, 28 WAIT TIMEThe unit will retransmit data when there is no response dur-ing the specified wait time.1. Move the cursor to WAIT TIME, then specify a time withthe [–] or [+] button. The default setting is OFF.Available wait times (ms): OFF, 100, 200, 400,1 0008 DELAY TIMEThis setting specifies a delay time that the unit suspends toreturn the response to the received command.1. Move the cursor to DELAY TIME, then specify a timewith the [–] or [+] button. The default setting is OFF.Available delay times (ms): OFF, 10, 20, 40, 1008 X-ON/X-OFF1. Move the cursor to XON/XOFF, then specify a modewith [–] or [+] button. The default setting is NOT USE.USE: Data flow control is enabled during communica-tion.NOT USE: Disabled.2. Press ESC to return to the WJ-MP204C SETUP MENU. System setup(Camera Communication Protocol)Parameters related to alarm, sync and remote functions areset in this menu for a Camera Communication Protocol sys-tem.The SYSTEM menu is displayed when you select it in theWJ-MP204C SETUP MENU.8 Alarm mode setupIn the SYSTEM menu, move the cursor to ALARM MODE.Select ON or OFF with the [–] or [+] button, then pressSET. The default setting is ON .ON : Opens a submenu shown below.OFF: Alarm mode is disabled.CAM ADDRESSCAMERA IN ADDRESS1CH 12CH 23CH 34CH 4SYSTEMALARM MODE ONCOMP/VD2/DATAVS/VD INPUT VDDAISY MODE ONTERMINAL ALARM