Panasonic WJ-SX550A Operating Instructions Manual

Panasonic WJ-SX550A Operating Instructions Manual Manual pdf 16 page image

-13-1. Log-inTo operate the Matrix Switcher System 500, a registeredoperator must first supply their Operator Number andPassword to the system controller.The operator number and password are established byusing the Set Up Menu. See page 83 for more details onoperator number registration.If an attempt is made to enter an operator number andpassword that do not match with the registered operatornumbers and passwords, entry into this system is denied.As shown in the examples below, there are 2 additionalattributes associated with an operator: operator level andpriority. These items are described in more detail on page19.Operator Name: MikeOperator Number: 01Operator Level: 01Password: 07171Priority: 1Operator Name: RobertOperator Number: 30Operator Level: 05Password: 11524Priority: 30Notes:1. Initially, Operator Number: 1Password: 12345are registered at the factory to allow access for firsttime system programming.2. An operator can be logged-in to this system from sev-eral system controllers.3. If the main power of the Matrix Switcher is turned off,log-in procedures must be performed again.4. If power to the system controller is turned off, the sys-tem controller will record operating status when poweris resupplied.2. Camera and Monitor SelectionAfter log-in, the desired camera and monitor combinationcan be selected.Basically, any combination of camera and monitor, whichare connected to this unit, can be selected as shownbelow.123General Procedures1. Select the desired monitor. (monitor and controller arelinked.)2. Select the desired camera (camera and controller arelinked.)3. The picture of the selected camera is displayed on theselected monitor.2-1 Monitor SelectionBy selecting the monitor with the System Controller, it islinked with the System Controller.At this time, the camera output signal that was last sup-plied to the monitor is displayed.Press the Numeric keys (1 to 16) then press the MON keyto select the desired monitor.CAMESC SET1 2 34 5 67 8 9MON 0For example: When selecting monitor No. 5:Press 5 then press MON key.Camera-1 Camera-2Monitor-1 Monitor-2WJ-SX550AControllerWV-RC1502