Panasonic WV-BS500 Operating Instructions Manual

Contents

- 27 -11. Auto Focus Setting (AF MODE)1. Move the cursor to AF MODE, and move the joystick to the left orright to set auto focus operation mode.MANUAL: The AF mode is activated by pressing the AF button of thecontroller.AUTO: AF mode is activated automatically after a manual panning,tilting or zooming operation.Note: AUTO in AF MODE is disabled unless SENS UP is set to OFF.If SENS UP is not OFF, AF MODE is set automatically toMANUAL.2. To set an areaMove the cursor to MANUAL or AUTO, and press the CAM (SET) key.The AF AREA SET menu is shown. Move the cursor to AREA, andmove the joystick to the left or right to select LARGE, MID or SMALLfor the area.3. To confirm operationTo check auto focus operation, move the cursor to AF CHECK, andpress the CAM (SET) key.Notes:• When the electronic sensitivity enhancement (SENS UP) is active, thisfunction is automatically set to MANUAL.• The auto focus lens may not function properly in AUTO under thefollowing conditions.1. Dirt or water on window glass.The auto focus may focus on the dirt or water.2. Low lighting/illumination or zone marker is blinking.3. Bright objects or high intensity objects.4. Single colour with unfigured object such as white wall or fine felt.5. No centre objects, sloping objects.6. Far and near objects on the screen.Important Notice:• The object of motion detection should meet the following conditions.1) It should be larger than 1/48 of the size of the picture screen.2) The contrast ratio (at max. detection level) between the objectand the background picture on the screen should be more than5%.3) The time it takes the object to move from one end of the screen tothe other should be more than 0.1 seconds.• Also under the following conditions, mask or adjust the detection levelto prevent malfunction.1) When leaves or curtains etc, are swayed by the wind.2) When a noisy picture exists such as under low light condition.3) When the object is subjected to illumination by lightingequipment that constantly turns on and off.• The alarm signal will take about 0.2 second to reach the alarmterminal of the VTR, after the camera detects the object.Because the alarm signal is multiplexed on the video signal it may bemistakenly interpreted by other video equipment as a time codesignal. Therefore, when this camera is not used in a PanasonicIntelligent CCVE System, select OFF to prevent the above fromoccurring.** SET UP **CAMERA ID OFF *ALC/MANUAL ALC *SHUTTER OFFAGC ONSENS UP OFFSYNC INTWHITE BAL ATW *WIDE D-RANGE OFFMOTION DET OFFAF MODE MANUAL *RET SPECIAL *Camera setting menu** AF AREA SET **AREA MIDAF CHECK →PUSH SWRET** AF AREA SET **AREA MIDAF CHECK →PUSH SWRETArea setting menu