Panasonic WV-CF224 Service Manual

Also see for WV-CF224: Operating instructions

Contents

Panasonic WV-CF224 Service Manual Manual pdf 7 page image

2-3(2). Installing E.V.R. Adjustment Program8 Make a copy of following necessary files to your comput-er from original floppy disk of the E.V.R. Adjustment Kit.LADJ.EXECF224P.SEQCF224P.EVR(3). Procedure1. Confirm that the CONFIG.SYS file on your computercontains DEVICE=ANSI.SYS.2. Insert floppy disk containing E.V.R.adjustmentprogram into your floppy drive (for example,drive:A)and type A:3. At the prompt, type CD IBMPC and press ENTER key.4. Type COPY LADJ.EXE B: and press ENTER key.5. Type CD\ and press ENTER key.6. Type CD SEQ and press ENTER key.7. Type COPY CF224P.SEQ B: and press ENTER key.8. Type CD\ and press ENTER key.9. Type CD EVR and press ENTER key.10. Type COPY CF224P.EVR B: and press ENTER key.11. After completing installation of program, you are readyto use the E.V.R. adjustment program.3.3. Setting Up8 An initial setting of the Switches SW1 on the SW Boardas follows:Synchronization Mode Selector (INT,LL)......................INTBack Light Compensation Mode Selector(BLC ON,OFF) ............................................................OFFAperture Level Selector(SOFT,SHARP)......................................................SHARP8 The adjustments should be done with this initial setting,unless otherwise specified.8 The adjustments should be done after 10 minutes warmup.3. Connection and Setting Up forAdjustment3.1. Connection8 The Fig. 3-1 shows the connection diagram for theAdjustment Procedure.Test ChartLensFloppy DiskVectorscopeUnderscannedColor VideoMonitor12 V DC or 24 V ACPower Supply UnitE.V.R.AdjustmentKitCable forE.V.R.Adjustmentit12 V DCPower Supply UnitPrinterConnectorPersonalComputer75ΩCAMERAFig. 3-18 Connect the probe of the Digital Voltmeter, Oscilloscopeor Frequency Counter at the desired Test Point in eachadjustment step.3.2. Setting Up for E.V.R. Adjustment Kit(1). Connecting for E.V.R. Adjustment Kit8 Referring to Fig. 3-1, connect the E.V.R. Adjustment Kitto CN3 on the Sensor Board of the Camera using theCable for E. V. R. Adjustment Kit.8 Connect the connector of the E.V.R. Adjustment Kit toPersonal Computer (IBM PC/AT type) using the printerconnector.8 Insert original floppy disk of E.V.R. Adjustment Kit to thecomputer.