Panasonic WV-CS580/G Installation Manual

Also see for WV-CS580/G: Operating instructions

Contents

185. Connect the cables.Please refer to page 20 for the details of connections.6. Attach the safety wire for securing the camera to thecamera mounting base.Pull on the safety wire to make sure its ring is securelyconnected to the camera mounting base hook.If the dust protect sheet that comes with the camerais affixed to the camera mounting base, remove itbefore performing the above step.Safetywire ringNote:• The safety wire is designed to allow the camerato hang from it. Do not apply force greater thanthe weight of the camera to the wire.7. Install the camera onto the camera mounting base.Aligning with the camera mounting base, pressdown on the camera as far as it will go and rotate inthe direction indicated by the arrow.Camera CameraMountingBaseRotate15°Note:• To prevent damage, please do not rotate whileholding the dome cover.8. Use the fixing screw you removed in step 1 tosecure the camera to the camera mounting base.Important:• Recommended tightening torque: 0.68 N . m.9. Check the installation.• Is the camera is level and installed securely?• Is the camera free of looseness?• Does the fixed part of the camera remain in placewhen you try to rotate it?10.Separate the two parts of the decorative cover(comes with camera).Press upwards on the decorative cover at the pointsmarked (indicated by the arrows, in theillustration below) to unhook the two parts from eachother.* When removing the decorative cover, the directionto press () is shown on the side of the decorativecover.UnhookBackFix securelyPressFix securelyPressCaution:• Pressing up on the wrong side of the decorativecover can damage it.11.Put the two pieces of the decorative cover on theleft and right side of the camera, and hook themtogether.Align the hooks and press the piece indicated by thearrow in the illustration below into the other piece.Back Alignhook12.Slide the decorative cover up to the ceiling.• In the case of a top cable exit configuration, slidethe decorative cover straight up and press it firmlyagainst the ceiling.• In the case of a side cable exit configuration, alignthe cut-out in the decorative cover with the cablesas you slide it up, and press it firmly against theceiling.Top Cable ExitConfigurationSide Cable ExitConfigurationAlign with cut-outCaution:• Please securely fix the 4 hooks inside thedecorative cover onto the camera.