Panasonic WV-CW484S Operating Instructions Manual

Also see for Super Dynamic III WV-CW484F: Brochure & specs Specification sheet Specifications Operating instructions Operating instructions

36AWC Setting1. Select AWC and press the [LEFT] button.→ AWC will change to AWC → PUSH SW.2. Press the [SET] button.→ PUSH SW will be highlighted while the AWC setting is performed.Note: If the white balance is not set, PUSH SW is being highlighted.3 . Press the [RIGHT] button.Manual Fine AdjustmentPerform fine adjustment as necessary.1. Select WHITE BAL and press the [SET] but-ton.→ Fine adjustment menu of ATW or AWC willopen.2. Adjust finely R (Red) and B (Blue) gain bymoving the "I" cursor.8. Motion Detection Setting (MOTION DET)When a series of changes in pictures is detected, the camera outputs an alarm to the externaldevice such as a disk recorder. The recorder will start recording the pictures.1. Select a mode for MOTION DET on the CAMERA SETUP menu.The default setting is OFF.OFF: Disables the alarm output.MODE1: Outputs alarm when a series ofmotions is detected.MODE2: Outputs alarm when a series ofscene changes is detected.→ The MODE1 menu opens when you selectMODE1 and press the [SET] button.2. Adjust for LEVEL to optimize the sensitivity ofdetection.3. Select a dwell time. The default setting is 2S.Available time (second): 2, 5, 10, 30The next detection will be performed afterthe set time elapses.4. Select MASK SET and press the [SET] but-ton.→ A 48-split screen opens.• Specify non-detection (mask) and detection areas in the same way as described earlier in2-2 ALC Mode.• Hold down the [SET] button for 2 seconds to return to the MODE1 menu.Note: Perform the setting of mask area after STABILIZER in the CAMERA SETUP menu isset to OFF.**ATW1**R ...I...128- +B ...I...128- +RET TOP END** MODE1 **LEVEL ...I..128- +DWELL TIME 2SDISPLAY MODEALARM OFFMASK SETRET TOP END↵↵