Panasonic WV-CW590G Operating Instructions Manual

Also see for WV-CS580: Specifications Preliminary

Contents

Panasonic WV-CW590G Operating Instructions Manual Manual pdf 27 page image

27Password settingsn Password Lock SettingsSet the password lock on the setup menu.l Turning Password Lock ON and OFFThe password lock function can be used to allow onlyauthorized personnel to change camera settings. Apassword must be input in order to turn password lockon or off.ON : Prohibits changing any settings except forthe password lock function.S e l e c t i n g t h i s s e t t i n g l i m i t s c a m e r aconfiguration changes to authorized personnel.OFF : Settings on all menus can be changed.If you are using a VTR for recording, turn off recordingbefore inputting the password. Inputting the passwordwhile the picture is being recorded by a VTR will causethe password to be recorded with the picture.1. Display the advanced setup menu (page 8), movethe cursor to PASSWORD LOCK (ON or OFF), andthen press the CAM (SET) button.This will display the password input menu.2. To set the password for the first time, enter thefactory default password "123" and then press theCAM (SET) button.Note:• You must use this procedure. The password LockON/OFF does not switch.3. Input a 3-digit password by moving the cursor toeach of the applicable numbers along the top of thescreen (0 to 9) and pressing the CAM (SET) buttonfor each digit.The ↑ pointer will move to the right each time youinput a digit. After you input all three digits, movethe cursor to OK.If you make a mistake during input, move the cursorto RESET, press the CAM (SET) button, and thenre-input the entire password.Note:• The factory default password is 123.4. Press the CAM (SET) button.This returns to the setup menu and togglesPASSWORD LOCK on or off.The password input screen will reappear if youpress the CAM (SET) button after inputting thewrong password. If this happens, perform step 3again.l Changing the PasswordAfter turning on password lock, it is recommended thatyou use the following procedure to change the factorydefault password to a different one. Also, make sureyou keep a separate record of your password so youdo not forget it.If you are using a VTR for recording, turn off recordingbefore inputting the password. Inputting the passwordwhile the picture is being recorded by a VTR will causethe password to be recorded with the picture.1. Display the setup menu (page 5), move the cursorto PASSWORD LOCK (ON or OFF), and then pressthe CAM (SET) button.This will display the password input menu.2. Input the current 3-digit password by moving thecursor to each of the applicable numbers along thetop of the screen (0 to 9) and pressing the CAM(SET) button for each digit.The ↑ pointer will move to the right each time youinput a digit. After you input all three digits, movethe cursor to OK.If you make a mistake during input, move the cursorto RESET, press the CAM (SET) button, and thenre-input the entire password.MODEL WV-CW590 SERIESCAMERAPAN/TILTALARMSPECIALCOMMUNICATIONSCENE SELECTLANGUAGE→ QUICK SETUPPASSWORD LOCK OFF** PASSWORD? **0 1 2 3 4 5 6 7 8 9. . .OK RESETNEW PASSWORDRET TOPMODEL WV-CW590 SERIESCAMERAPAN/TILTALARMSPECIALCOMMUNICATIONSCENE SELECTLANGUAGE→ QUICK SETUPPASSWORD LOCK OFF** PASSWORD? **0 1 2 3 4 5 6 7 8 9. . .OK RESETNEW PASSWORDRET TOP