Panasonic WV-CW960/G Operating Instructions Manual

Panasonic WV-CW960/G Operating Instructions Manual Manual pdf 23 page image

-23-■ Scene Select SettingsDisplay the scene select setting menu from the setupmenu to configure scene select settings. First, displaythe scene select setting menu.1. Display the setup menu (page 22), move the cursorto SCENE SELECT O, and then press the CAM(SET) button.This will display the scene select setting menu.● Scene Select SettingsUse the following procedure to configure scene selectsettings.1. Move the cursor to SCENE, and then tilt the joystickleft or right to change the scene setup.INDOOR (L) : Indoor setting (picture qualitypriority)INDOOR (H) : Indoor setting (sensitivitypriority)OUTDOOR (L) : Outdoor setting (picturequality priority)OUTDOOR (H) : Outdoor setting (sensitivitypriority)Settings related to the picture switch depending onthe scene settings. Scene select settings andrelationship to other settings are shown in the tablebelow.2. Move the cursor to LOAD, and then press the CAM(SET) button.This will cause the setup you selected for SCENE instep 1 to be applied to the image.■ Preset Position Settings● Position Number Selection (MAP)You could use the MAP item on the pan/tilt setup menuinstead of the PRESET item to select a positionnumber.1. Move the cursor to PRESET POSITION O, and thenpress the CAM (SET) button.2. Move the cursor to the number you want to select,and then press the CAM (SET) button.This registers the position number setting anddisplays the preset setting menu. (this page)To select a position number in the range of 033 to064, move the cursor to 33-64 in the lower left cornerof the menu, and then press the CAM (SET) button.Preset numbers set subsequently are the same.Notes:• An asterisk (*) to the right of a position numberindicates that it already has a preset positionassigned to it.The home position number is indicated by theletter H next to the asterisk.• When the cursor is located at a position numberthat has a position ID, the position ID textappears next to ID: on the menu screen.● Position Setting (POSITION SET)The position setting can be used to specify the cameraposition (pan and tilt), the lens zoom setting, and thefocus setting.1. Move the cursor to POSITION SET O and press theCAM (SET) button to display the position setting menu.**SCENE SELECT**SCENE INDOOR(L)LOADRET TOPAGC SENS UP SHUTTERINDOOR (L) MID OFF OFFINDOOR (H) HIGH ×2 AUTO OFFOUTDOOR (L) MID OFF AUTOOUTDOOR (H) HIGH ×2 AUTO AUTOBW DNR WHITE BALINDOOR (L) OFF LOW ATW1INDOOR (H) OFF HIGH ATW1OUTDOOR (L) AUTO LOW ATW2OUTDOOR (H) AUTO HIGH ATW2**PRESET POSITION**261014182226301*591317212529ID:DOOR033-064 225-256RET TOP3711151923273148121620242832**PRESET POSITION**34384246505458623337414549535761ID:065-096 001-032RET TOP35394347515559633640444852566064PRESET NO. 1*POSITION SETPRESET IDRET TOP DELON