!1 !2 !3 !4 !5 !6!7 !8 !9@0 Rear View!1 ClampAfter connection of the power cord and HDMI cable,remove the screw that secures the cord clamp and fas-ten the power cord and HDMI cable.!2 Power input jack (AC IN)Connect the power cord (accessory).!3 Audio input connector (AUDIO IN)With an audio cable connection, this connector acceptsan audio signal from an external device and supplies thesignal to the built-in speaker.Note:• When HDMI is selected for input, audio output is provid-ed not from this terminal but from the HDMI connector.!4 HDMI input connector (HDMI)Accepts an HDMI signal (video/audio) from an externaldevice.For timing data this connector supports, refer to page 11"Timing data chart for HDMI input".!5 PC input connector (PC IN)Accepts an analog RGB signal from a PC.For timing data this connector supports, refer to page 11"Timing data chart for PC input".!6 VIDEO input connector (VIDEO IN)Accepts a composite video signal from an externaldevice.!7 Video output connector (VIDEO OUT)Supplies a composite video signal accepted by theVIDEO IN connector to another external device.!8 Security slotYou can attach a lock that meets the industry standardspecification (3 to 3.26 mm x 7 to 7.26 mm x 3.5 to4 mm).!9 Fall-prevention clampUse a strong cord or chain (locally procured) to securethis monitor to a solid wall or column for fall prevention.Remove the clamp when a mounting bracket for wallinstallation is used.@0 Screw holes for wall mounting bracket ( page 20)10(This illustration represents WV-LW2200.)