Panasonic WV-NS202 Network Operating Instructions

Also see for WV-NS202 - i-Pro Network Camera: Integration note Network operating instructions Instructions

Contents

7In this case, the camera will not move when thethumbnail image is clicked. (For example, when pre-set position 3 is unregistered, the thumbnail imageof preset position 2 will be displayed as the thumb-nail image of preset position 3. The camera will notmove when the thumbnail image of preset position 3is clicked.)• The camera will not always returns to the exactlysame position where it was before "360° map-shot"or "Preset map-shot" was carried out. (It may some-times be slightly different.)• The window on which the thumbnail images are dis-played will close when Clicking the following buttonsthat can switch the camera channel or reloadimages.[Live] button, multi-screen buttons, image type but-tons ([MPEG-4]/[JPEG]), image capture size buttons([VGA]/QVGA), full screen button, [Setup] button( pages 5 - 7)To display the thumbnail images again, carry out"360° map-shot" or "Preset map-shot" again.!1 Control pad/buttons (*2): Left-click on the control pad to adjustthe horizontal/vertical position of thecamera (panning/tilting).Panning/tilting speed will be faster if aclicked point gets farther from the cen-ter point of the control pad.It is also possible to pan/tilt the camera by dragging themouse.Zoom and focus can be adjusted by right-clicking. Whenan upper/lower area of the control pad is right-clicked,the displayed image will be zoomed in/out on. When aleft/right area is right-clicked, the focus will be adjustedto the NEAR/FAR side.Zoom can also be adjusted using the mouse wheel.!2 BRIGHTNESS buttons (*2): The displayed image will be darker.: The adjusted brightness will return to thedefault brightness.: Image will be brighter.Note:When the BRIGHTNESS buttons are clicked whilethe camera is at the preset position, the adjustedbrightness will automatically be registered for thecurrent preset position.!3 PRESET (*2)Select a preset position from the pull-down menuand click the [GO] button. The camera will move tothe selected preset position ( page 36). "H" next tothe preset position number indicates the home posi-tion. When "Home position" is selected, the camerawill move to the home position.When the preset ID is registered for a preset posi-tion, the registered preset ID will be displayed nextto the preset position number.!4 Camera titleThe camera title entered for "Camera title" on the[Basic] tab will be displayed. ( page 19)!5 Alarm occurrence indication button (*2)This button will be displayed and will blink when analarm has occurred. When this button is clicked, thealarm output terminal will be reset and this buttonwill disappear. ( page 47)!6 Full screen buttonImages will be displayed on a full screen. To returnto the "Live" page, press the [Esc] key or the [F5]key, or the combination of the [Alt] key and the [F4]key on the keyboard.!7 One shot buttonClick this button to take a picture (a still picture). Thepicture will be displayed on a newly opened window.When right-clicking on the displayed image, the pop-up menu will be displayed. The displayed image canbe saved on the PC by selecting "Save" from thepop-up menu.!8 Mic input button (*3)Turns on/off the audio reception (hear audio fromthe camera on a PC). This button will be displayedonly when "Mic input" or "Interactive" is selected for"Audio mode" on the setup menu. ( page 40)When this button is clicked, the button will turn intothe button and audio from the camera will not beheard.Audio volume can be adjusted (Low/Middle/High) bymoving the volume cursor .