Panasonic WV-NW470S Operating Instructions Manual

Panasonic WV-NW470S Operating Instructions Manual Manual pdf 22 page image

Opening the camera setup menu■ Camera Setup Menu (CAMSETUP)1. Camera Identification (CAMERA ID) SettingYou can assign a name to the camera. The camera IDconsists of up to 16 alphanumeric characters. Thecamera ID display can be switched on and off on themonitor screen.-22-SETTING PROCEDURESThe following pages describe setting operations from the camera.For accessing from the PC, interpret these instructions as follows.Escaping from the VMD mask setupetc.FunctionClosing the camera setup menuOpening a more detailed setupmenuReturning to the previous menuOpening the special menuResetting the parameter of an itemResetting all the settingsSelecting an itemSelecting a parameterValidating the selectionHold down the [SET] button for 2 seconds.Press the [SET] button while the cursor isat END.Press the [SET] button while the cursor isat an item tailed with O mark.Press the [SET] button while the cursor isat RET.Hold down the [Left] and [Right] buttonssimultaneously while the cursor is at ENDin CAM SETUP.Hold down the [Left] and [Right] buttonssimultaneously while the cursor is at theitem.Hold down the [Left], [Right], and [SET]buttons simultaneously while the cursor isat CAMERA RESET.Press the [Up] or [Down] button.Press the [Left] and [Right] button.Press the [SET] button.Hold down the [SET] button for 2 seconds.Click the Camera Setup button in themain page to display the menu controlbuttons.Click the [MENU ON] button.Click the [MENU OFF] button.Click the [SET] button while the cursor isat the item tailed with O mark.Click the [SET] button while the cursor isat RET or simply clock the [ESC] button.Click the [RESET/SPECIAL] button whilethe cursor is at END in CAM SETUP.Click the [RESET/SPECIAL] button whilethe cursor is at the item.Click the [ALL RESET] button while thecursor is at CAMERA RESET.Click the [D] or [C] button.Click the [A] or [B] button.Click the [SET] button.Click the [ESC] button.From the Camera From the PC■ Setup Selection1. Move the cursor to CAMERA or NETWORK, andpress [SET] to open the desired setup menu.CAMERAN: Opens the CAMERA SETUP menu.NETWORKN: Opens the NETWORK SETUP menu.2. Move the cursor to END, and press [SET] to returnto camera image screen.Note: When SETUP DISABLE appears in the bot-tom line you cannot change the currently activesettings. This disablement is designed to pre-vent accidental setting change. Refer to the pre-vious page to change it to ENABLE.** SET UP **CAMERANETWORKEND SET UP DISABLE↵↵0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ().,'":;&#!?=+-*/%$ÄÜÖÆÑÅSPACEPOSI RET END RESET................Character CursorCursorCharacterAreaCommandEditingAreaCAMERA ID menu** CAM SET UP **CAMERA ID OFFALC ALCSHUTTER ---AGC ON(DNR-H)SENS UP OFFSYNC INTWHITE BAL ATW1MOTION DET OFFMENURET END↵↵ ↵