Panasonic WV-NW470S Operating Instructions Manual

Panasonic WV-NW470S Operating Instructions Manual Manual pdf 7 page image

-7-MAJOR OPERATING CONTROLS & THEIR FUNCTIONSABLEFTRIGHTUPDOWNSET LINKLEDOFF LEDONRCVABL EFTR IGHTU PD OWNSET LINKLEDOFF LEDONRCVuio!0!1 !2!3!4!5!6!7!9!8t rqywTransport ProtectionScrews (Red)eq Tilting lock screwFixes the tilting position.w Panning tableAdjusts the panning angle of the camera.e Azimuth adjusterAdjusts the azimuth angle to level the image.r Pan lock screwFixes the panning position.t Zoom lock leverFixes the zoom position after adjustment.y Focus lock leverFixes the focus position after adjustment.u Optional heater connectorWhen an optional heater unit is installed in the cam-era, the harness exiting from the unit will be con-nected to this.i Reset button (A)Holding down the Up and Down buttons simultane-ous for 15 seconds in the power-on state will resetthe network setup parameters.Note: Never press both reset buttons A and B at thesame time.o Reset button (B)Holding down the Up and Down buttons simultane-ously for 15 seconds in the power-on state will resetthe HTML files and alarm mail setup.!0 LED switchON: Enables the LINK and RCV LEDs toindicate the communication status.OFF: Disables the status indication.Note: Normally set the switch to OFF. Set itto ON only when you check the communicationstatus. Failure to do so may cause disturbance tothe camera image, or light leakage to the outsideof the camera in dark places.!1 Link indicator (LINK)Lights up when establishing communications via thenetwork if the LED switch is set to ON.!2 Receive indicator (RCV)Lights up when receiving data via the network if theLED switch is set to ON.!3 Left button (Left)Moves the cursor to the left, selects the mode, andadjusts some levels.!4 Right button (Right)Moves the cursor to the right, selects the mode, andadjusts some levels.!5 Up button (Up)Moves the cursor upward and selects items in themenu setup.!6 Down button (Down)Moves the cursor downward and selects items in themenu setup.OFFON