[Time adjustment]Select the time adjustment method from the following. Time adjusted by the selected method will be used asthe standard time of the camera.• Manual: Time set on the [Basic] tab on the “Basic” page will be used as the standard time of the camera.• Synchronization with NTP server: Time automatically adjusted by synchronizing with the NTP serverwill be used as the standard time of the camera.• Default: Manual[NTP server address setting]When “Synchronization with NTP server” is selected for “Time adjustment”, select the method of how to obtainthe NTP server address from the following.• Auto: Obtains the NTP server address from the DHCP server.• Manual: The NTP server address will be entered manually on “NTP server address”.• Default: ManualIMPORTANT• When obtaining the NTP server address from the DHCP server, it is necessary to select “DHCP” or“Auto” for “Network Settings” on the [Network] tab of the “Network” page. (®page 111)[NTP server address]When “Manual” is selected for “NTP server address setting”, enter the IP address or the host name of the NTPserver.• Available number of characters: 1 - 128 characters• Default: None (blank)IMPORTANT• When entering the host name for “NTP server address”, it is necessary to configure the DNS settingson the [Network] tab of the “Network” page. (®page 111)[NTP port]Enter a port number of the NTP server.• Available port number: 1 - 65535• Default: 123The following port numbers are unavailable since they are already in use.20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 161, 162, 443, 554, 995, 10669, 10670, 59000-61000[Time adjustment interval]Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization with the NTP server.• Default: 1h[Time zone]Select a time zone corresponding to the location where the camera is in use.• Default: (GMT) Greenwich Mean Time: Dublin, Edinburgh, Lisbon, London110 Operating Instructions16 Configure the settings of the servers [Server]
