IPv4 network[Network Settings]Select the method of how to configure the IP address from the following.• Static: The IP address is configured by entering manually on “IP address(IPv4)”.• DHCP: The IP address is configured using the DHCP function.• Auto(AutoIP): The IP address is configured using the DHCP function. When the DHCP server is not found,the IP address is automatically configured.• Auto(Advanced): Using the DHCP function, network address information is referred to, and an unusedIP address is configured to the camera as a static IP address. The configured IP address is automaticallydetermined within the subnet mask range by the camera. When the DHCP server is not found, the IPaddress is set to 192.168.0.10.• Default: Auto(Advanced)Note• When “Auto(AutoIP)” is selected and the IP address cannot be obtained from the DHCP server, an IPaddress not used in the same network will be searched within 169.254.1.0 - 169.254.254.255.[IP address(IPv4)]When not using the DHCP function, enter the IP address of the camera. Do not enter an IP address alreadyin use (for the PCs and the other network cameras).• Default: 192.168.0.10Note• Multiple IP addresses are unavailable even when using the DHCP function. Refer to the networkadministrator for further information about the settings of the DHCP server.[Subnet mask]When not using the DHCP function, enter the subnet mask of the camera.• Default: 255.255.255.0[Default gateway]When not using the DHCP function, enter the default gateway of the camera.• Default: 192.168.0.1Note• Multiple IP addresses for the default gateway are unavailable even when using the DHCP function.Refer to the network administrator for further information about the settings of the DHCP server.[DNS]Determine how to set the address of the DNS server by selecting “Auto” (obtain the address automatically) or“Manual” (enter the address of the DNS server). When “Manual” is selected, it is necessary to configure thesettings for the DNS.When using the DHCP function, it is possible to obtain the DNS address automatically by selecting “Auto”.Refer to the network administrator for further information about the settings.• Default: Auto[Primary server address], [Secondary server address]When “Manual” is selected for “DNS”, enter the IP address of the DNS server.Refer to the network administrator about the IP address of the DNS server.140 Operating Instructions16 Configuring the network settings [Network]
