is pressed and held down (about 2 seconds). The recorded data may become corrupted if the SDmemory card is removed when the SD MOUNT indicator is lit in green.• When an SD memory card is replaced after pressing and holding (about 2 seconds) the SD ON/OFFbutton, press the SD ON/OFF button and confirm that the SD MOUNT indicator is lit in green. If theSD ON/OFF button was not pressed, the SD MOUNT indicator will light in green for about 5 minutesafter replacing the SD memory card.• When an SD memory card is inserted when “Use” is selected, data will be saved in accordance withthe setting of “Save trigger”.• After inserting the SD memory card, it is necessary to select “Use” to use the SD memory card.• When the image refresh interval is short, notification/recording timing or interval may become incorrect.Notification/recording may also not be performed correctly as configured when multiple users arereceiving images. In this case, set the refresh interval longer.• There are limited times to overwrite on an SD memory card. When having a high frequency ofoverwriting, the lifetime of the SD memory card may become shorter.• A lifetime of an SD memory card should be influenced by the number of the image files stored and logsavings on the SD memory card. Selecting “H.264(1)”, “H.264(2)”, “H.264(3)”, or “H.264(4)” for“Recording format” can reduce the number of files to be stored on the SD memory card.• If the data writing speed goes down after data is repeatedly written on an SD memory card, werecommend replacing the SD memory card.Operating mode[Audio recording]Select whether or not to save audio data when saving video data in MP4 format.• Off: Does not save audio data to videos (MP4 format).• On: Saves audio data (AAC-LC format) to videos (MP4 format).Default: Off[Remaining capacity notification]When the E-mail notification function or the Panasonic alarm protocol function is used to provide notificationof the remaining capacity of the SD memory card, select a level to be notified at from the following.50%/ 20%/ 10%/ 5%/ 2%• Default: 50%Note• Notification will be provided each time the remaining capacity of the SD memory card reached thevalues above.For example, notification will be provided each time the remaining capacity reaches 50%, 20%, 10%,5% and 2% when “50%” is selected. Notification may not always be made at the very moment whenthe remaining capacity of the SD memory card has reached each value.[Overwrite]Determine whether or not to overwrite when the remaining capacity of the SD memory card becomesinsufficient.• On: Overwrites when the remaining capacity of the SD memory card becomes insufficient. (The oldestimage is the first to be overwritten.)• Off: Stops saving images on the SD memory card when the SD memory card becomes full.• Default: OffOperating Instructions 5310 Configure the basic settings of the camera [Basic]
