68Configure the settings relating to Panasonic alarm protocol [Notification]Click the [Notification] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)The settings relating to Panasonic alarm protocol can be configured in this section.■ Panasonic alarm protocol notification[Panasonic alarm protocol]Select "On" or "Off" to determine whether or not to pro-vide notification by Panasonic alarm protocol accordingto the settings for the "Alarm" and "Diag." checkboxesof "Destination of notification" below.• When an alarm is detected ("Alarm")• When a notification of the remaining capacity of theSD memory card has been provided ("Diag.")• When the SD memory card has become full ("Diag.")• When the SD memory card cannot be recognized("Diag.")Default: OffNote:• When "On" is selected, notification of the alarmoccurrence will be provided to the registered desti-nation addresses in order (to IP address 1 first, to IPaddress 8 last).[Destination port]Select a destination port for the Panasonic alarm proto-col from the following.Available range: 1-65535Default: 1818[Retry times]Select a retry time for the Panasonic alarm protocol.Available range: 0 - 30Default: 2■ Destination of notification[Address 1] - [Address 8]Enter the destination IP address of the Panasonic alarmprotocol from the following. Host name is unavailablefor the IP address. Up to 8 destination addresses canbe registered."Alarm" checkbox: When the checkbox is checked,the Panasonic alarm notification will be providedupon an alarm occurrence."Diag." checkbox: When the checkbox is checked,notification using Panasonic alarm protocol will beprovided in the following cases.• When notification of the remaining capacity ofthe SD memory card has been provided• When the SD memory card has become full• The SD memory card cannot be recognized"Destination IP address": Enter the destinationaddress.To delete the registered IP address, click the [Delete]button respective to the desired IP address.Important:• Confirm that the destination IP addresses are regis-tered correctly. When a registered destination doesnot exist, notification may be delayed.
