89Reset the settings/Reboot the camera [Default reset]Click the [Default reset] tab of the "Maintenance" page. (☞ Pages 22 and 23: How to display/operate the setupmenu)The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed onthis page.[Reset to the default (Except the network settings)]Click the [Execute] button to reset the settings to thedefault. Note that the network settings will not be reset.It is impossible to operate the camera for around 2 min-utes after the initialization.[Load the default HTML files (setup menu).]Click the [Execute] button to reset the HTML files to thedefault.It is impossible to operate the camera for around 2 min-utes after the initialization.[Reset to the default and load the default HTMLfiles.]Click the [Execute] button to reset the settings of thecamera and the HTML files to the default. Note that thenetwork settings will not be reset.It is impossible to operate the camera for around 2 min-utes after the initialization.[Reboot]Click the [Execute] button to reboot the camera. It isimpossible to operate the camera for around 2 minutesafter rebooting the camera.Note:• To initialize the network settings (☞ page 78), turnoff the power of the unit, then turn on the poweragain while holding down the [INITIAL SET] buttonon the unit for 5 seconds. Wait around 2 minutesafter releasing the button. The unit will start up andthe settings including the network settings will beinitialized. Do not turn off the power of the unitaround 2 minutes just after turning on the power.• The notification function allows users to provide thenotification of the error to the specified mail addressand an original alarm destination when an error suchas no SD memory card insertion after the reboot ora locked SD memory card insertion occurs.(☞ Pages 67 and 68)
