Panasonic WX-CT2020 Operating Instructions Manual

Also see for WX-CT2020: Operating instructions

Contents

7● Channel Group SelectionYou can select a channel group by setting the channelselector, which is the rotary switch inside the switch pocket.1. Press the power button to turn off the order taker unit.2. Set the switch to the channel group.Available Channel Group: 1 - 8Notes:• When a switch position other than 1 through 8 is select-ed, the power indicator will blink in red.• Be sure to turn off the order taker unit in Step 1.Otherwise, the channel group will not be activated untilyou turn off and on the power again.● DIP Switch SetupAn eight-bit DIP switch is provided for system setups. Theinitial settings are marked with an asterisk *.1. Press the power button to turn off the order taker unit.2. Set the switches as follows.SW#1: For selection of a radio frequency suitable forthe locationON: Applies the US frequency to the headset.OFF: Applies the Canadian frequency.12345 6 78G1 2 3 4 5 6 7 8Channel selector1SW#2345678LocationFunctionTone SquelchTalk Lock ResumptionUSA*ONON*ONCanadaOFFOFFOFF*OFF*OFF*OFF*OFF*OFF*SW#2: OFFSW#3: OFFSW#4: OFFSW#5: OFFSW#6: This switch selects the mode of Tone Squelchmethod.ON: The audio is output detecting the Tone Squelchsignal from the Center Module.OFF: The audio is output in disregard of the ToneSquelch signal from the Center Module.Note: Normally, set SW#6 to ON. Pay attention to highlevel noise that may be output when set to OFF.SW#7: While talking with a customer in the Talk Lockmode, you may need to contact store personnel inthe Page PTT or Page Lock mode, which interruptsthe Talk Lock mode. This switch specifies the statusof the interrupted Talk Lock mode after ending thePage PTT or Page Lock mode.ON: Resumes the Talk Lock mode.OFF: Releases the Talk Lock mode.SW#8: OFFNote: Be sure to turn off the order taker unit in Step 1.Otherwise, the channel group (refer to "ChannelGroup Selection") will not be activated until you turnoff and on the power again.