Paradyne 3360 User Manual

Also see for ACCULINK 3360: Quick installation Operator's guide Operator's guide

Paradyne 3360 User Manual Manual pdf 37 page image

ACCULINK 336x E1 NTU3-14 June 1996 3360-A2-GB20-10To copy the configuration options to one or all ports,6. From the Port Select screen, select Copy.F1Port Select:Copy Prt1 Prt2F2 F37. Select the port from which you want to copy theconfiguration options using the correspondingFunction key.F1Copy From:Prt1 Prt2 Prt3F2 F38. Select the port to which you want to copy theconfiguration options using the correspondingFunction key. Or, press F1 (All) to choose to copyto all ports.F1Copy To:All Prt1 Prt2F2 F3Configuring the E1 NTU forSNMP ManagementTo configure the E1 NTU for management by anSNMP management system you must,• Select and configure the port that provides the linkto the SNMP management system.• Set the Internet Protocol (IP) address and subnetmask needed to access the device (see Appendix F,IP Network Addressing Scenario).• Select the link layer protocol (PPP or SLIP) for theport.• Specify the two community names that are allowedto access the device’s Management InformationBase (MIB).• Configure the device to send traps to the SNMPmanager, if desired.Selecting the PortThe SNMP manager or network device (e.g., a router)can be directly connected to the communications (COM)port. An external LAN Adapter can be connected to eitherthe COM port or the auxiliary (AUX) port to provideEthernet or Token Ring connectivity. Also, the E1 NTUcan be daisy chained together by connecting the COMport of one device to the AUX port of the other, providingSNMP connectivity.The COM port can support either synchronous orasynchronous PPP, or asynchronous SLIP at data rates ofup to 38,400 bps. The AUX port can support data rates upto 38,400 bps.The example shown below assumes that the COM portis being used as the link to the SNMP manager.To select the COM port as the management link,1. From the top-level menu screen, select Cnfig.2. Select the configuration option set to be copiedinto the Edit area by using the appropriateFunction key. Use the scroll keys, if necessary.3. Select Edit.4. From the Edit screen, press the key until theUser selection appears on the screen.5. Select User.F1Edit:Chan Gen UserF2 F36. Press F1 (Next) until the Com Use configurationoption appears.