Paradyne ACCULIN 3364 Operator's Manual

Also see for ACCULIN 3364: Quick installation

Contents

Paradyne ACCULIN 3364 Operator's Manual Manual pdf 102 page image

ACCULINK 3360, 3364, and 3365 E1 NTUC-8 March 1999 3360-A2-GB20-30Channel ConfigurationOptionsThe Channel configuration options are divided into twotables as follows:• DTE Channel Configuration Options (Table C-4)• Data Port Channel Configuration Options(Table C-5)NOTETables C-4 and C-5 describe theDTE and data port configurationoptions. For information about theoperation of Display and Clear,refer to theConfiguring DS0Channels section in Chapter 3,Operation.Table C-4DTE Channel Configuration OptionsDTE Channels:TS16 AssignG.703 DTE Channel. Allows the selection of time-slot 16 (TS16) for signaling information or assigns DS0 channels fromthe G.703 DTE interface to DS0 channels on the network interface.TS16 – Allows the selection of TS16 for signaling information (see the TS16 configuration option below).Assign – Allows the assignment of DS0 channels from the G.703 DTE interface to the network interface.TS16: DataData Rsvd CASG.703 DTE TS16 Allocation. Specifies whether time-slot 16 (TS16) is reserved for signaling information or available fordata.Data – Specifies that TS16 is available for data.Rsvd – Specifies that TS16 is reserved for Common-Channel Signaling information. The time slots must be directlyconnected so that the G.703 DS0 channels are connected to the corresponding network DS0 channels (e.g., D1 to N1,D2 to N2, etc.).CAS – Specifies that TS16 is reserved for Channel-Associated Signaling information. Except for time-slot 16, the othertime slots do not need to be directly connected as they are in Common-Channel Signaling.NOTE: Changing this configuration option from one selection to the other (Data, Rsvd, or CAS), deallocates all DS0channels assigned to either the network interface or the G.703 DTE interface.N1 N2 N3 N4 N5 N6 N7 N8 N9 N10 N11 N12 N13 N14 N15 ... N31– – – – – – – – – – – – – – – ... –G.703 DTE Channel Allocation. Assigns DS0 channels from the G.703 DTE interface to the network interface.Line 1 displays the 31 channels for the network interface. Line 2 displays what is allocated to the DS0 channel indicatedin Line 1. Possible values for Line 2 are:Value Meaning– This DS0 channel is not allocated. You can modify this value on this screen.Prtn This DS0 channel is allocated to portn, wheren is a number from 1 to 4. You cannot modify this valueon this screen.Dn This DS0 channel is allocated to the G.703 DTE interface DS0 channeln, wheren is a numberfrom 1 to 31. You can modify this value on this screen.Assign DTE channels to network channels by pressing the Function key below the network channel desired. The DTEchannel number scrolls up one number each time you press the Function key. Only unassigned DTE channels appearduring scrolling.NOTE: If time-slot 16 is reserved for signaling (see the TS16 configuration option), D16 is automatically allocated to N16and will not be available for allocation on this screen.