Paradyne HOTWIRE 7924 User Manual
Also see for HotWire 7924: User guideUser guideUser guide
                                                        | |
Contents
| 
Customizing DSX-1-Compatible Units4-57924-A2-GB20-10PRELIMINARY DRAFTJune 1997Options 6 and 7 (Switchpack and Line Build-Out Definitions) on the Config menudisplay the switchpack and jumper positions used when changing configurationchanges manually. These options are described in later sections of this chapter.Making Changes in Switchpack ModeWhen operating in Switchpack Mode, you can change configuration options bymoving switches on the board hardware.To enable Switchpack Mode, refer toSwitching Between Terminal andSwitchpack Modes in Chapter 3. ProcedureTo open the unit and make changes while in Switchpack Mode:1. Power down the unit and remove the enclosure cover, exposing the circuitboard. Use electrostatic discharge (ESD) protection when handling the circuitboard.2. Refer to the board layout illustration inSwitchpacks and Jumpers,Appendix C to locate switchpack S1.3. Place the switchpack in the correct position for each desired configurationoption. Definitions of switchpack positions are provided inSwitchpacks andJumpers, Appendix C.For example, to change a unit’s card type from CO to CP, move switch 1 onswitchpack S1 to the OFF position.4. Replace the enclosure cover and power up the board to reset and enable thenew configuration.Displaying Switchpack DefinitionsEnter 6 at the Config prompt to display the definition of each position in theswitchpack. Switchpack definitions are also listed inSwitchpacks and Jumpers,Appendix C.Config→ 6Switch pack definition: (OFF=0, ON=1)1 – CO/CP OFF=CP, ON=CO2 – B8ZS OFF/ON3 – Dual/Single Loop Mode OFF=Dual, ON=Single4 – Line Build Out Bit 05 – Line Build Out Bit 16 – Line Build Out Bit 27,8 – 00=Unframed, 01=D411=ESFConfig→ |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine