English 1-13Getting Started - GKP Setup WizardThe GKP can be fitted remotely – see Chapter 4 Installation of the AC30 Product Manual for details.Purpose of the Setup WizardThe purpose of the setup wizard is to configure the drive in as clear and concisemanner.Starting the Setup WizardThe Setup Wizard is automatically invoked when the drive is reset to factory defaultsettings. The setup wizard may be invoked at any other time by changing theparameter “Run Setup?” to YES (you will find this under “Commissioning::QuickSetup::") then returning to the top of the menu tree, (by pressing the left keyrepeatedly.Running the Setup WizardOn entry to the Setup Wizard, the first action is to set the language that is to be used. The language may beselected by using the UP and DOWN keys. Pressing the OK key confirms the selection and moves on to thenext step.The rest of the Setup Wizard consists of a several sections. Each section corresponds to a functional componentof the drive, for example: Application selection Motor Data Analog input and output ranges Fieldbus options On-board Ethernet AutotuneIf not required, any section may be skipped.The default setting for all parameters depends on earlier answers and on the physical configuration of the drive.All data entered is automatically saved without the need for any additional commands.Finalising SetupOnce the Setup Wizard has been run to completion the feature is automatically disabled. Re-starting the drivewill not cause the Setup Wizard to be run again. (If it is desired to re-run the Setup Wizard, this can be achievedas detailed above in “Starting the Setup ”).Ethernet CommunicationsConnecting and disconnecting the Ethernet cable.See Chapter 12 Ethernet of the AC30 Product Manual for this information.