3-2 Installing the DriveAC890PX AC DriveStep 1: Mechanical InstallationIMPORTANT The AC890PX is classed as a "Complete Drive Module". DO NOT install external equipment into the AC890PXenclosure.Main Points This is a standalone unit. Provide adequate ventilation. Avoid excessive vibration.NOTE Refer to Appendix C for information about EMC compliance.1.1: Mounting the DrivePrepare a clear, flat surface to receive the drive before attempting to move it.It may be lifted by forklift either in it its final upright position, or lying on its back.The drives are supplied with 4 lifting eyes fitted to the top of the drive enclosure for handling using a hoist.During operation it must stand vertically on a solid, flat, horizontal, normally cool, non-flammable surface. With any tall unitsuch as the AC890PX drive, it is advisable to secure the top to prevent it tipping over.NOTE The bottom wire entry version of the drive will sit on a plinth (allowing the cables to be fed through the bottom of thedrive). In this case, also secure the drive to the plinth.Drive Weights132kW 600lbs (272kg)200kW 600lbs (272kg)315kW 732lbs (333kg)400kW 790lbs (360kg)