Parker Compumotor OEM350 User Manual

Parker Compumotor OEM350 User Manual Manual pdf 11 page image

INSTALLATION • OEM650/OEM650X4OptionDescription-DS23 Double Shaft Size 23 Motors-DS34 Double Shaft Size 34 MotorsTable 2-4. Double Motor Shaft OptionThe following accessories are available.AccessoriesPart NumberOEM650/OEM650X User Guide 88-013157-02OEM Series Software Ref. Guide 88-013785-01Low Current Heatsink OEM-HS1High Current Heatsink OEM-HS2Table 2-5. OEM650/OEM650X AccessoriesEvaluation kitsEvaluation kits include all items necessary to evaluate the OEM650(OEM650-EK) and OEM650X (OEM650X-EK) in a simulated produc-tion environment. The kits are intended to be used to prototype amachine or operation before production units are purchased. Thefollowing items are included in an evaluation kit. Motors must beordered separately—they are not included in the kit. If a componentis missing, contact Compumotor's Customer Service Department.PartPart NumberDrive or Drive/Indexer OEM650or OEM650XOEM650/OEM650X User Guide 88-013157-02OEM Series Software Ref. Guide 88-013785-01High Current Heatsink OEM-HS2Ship kit Items:❐ Resistors (for current selection—the following types are available)• 21.0KΩ 1% Resistor 12-008319-01• 5.76KΩ 1% Resistor 12-008265-01• 15.8KΩ 1% Resistor 12-008307-01• 2.05KΩ 1% Resistor 12-008222-01• 12.7KΩ 1% Resistor 12-008298-01• 0.00KΩ 5% Resistor 12-003645-01• 9.53KΩ 1% Resistor 12-008286-01• 4.87KΩ 1% Resistor 12-008258-01• 1.27KΩ 1% Resistor 12-008202-01❐ Screwdriver 58-013155-01❐ 25-Pin D Mating Connector 43-001989-01❐ X-Ware Support Disk (OEM650X-EK Only)• 3 1/2" Disk 95-013066-01• 5 1/4" Disk 95-013067-01Table 2-6. OEM650 Series Evaluation kit ContentsQuick Test (OEM650/OEM650X)Use the following steps to set the drive’s jumpers, wire the unit, andtest your system. You will need the following tools:❐ Needle nose pliers or tweezers❐ Flathead screw driver (1/10")