Parker IQAN-MC31 Instruction Book

29Start-up procedures7 Start-upInstruction book, IQAN7 Start-upStart-up proceduresThis chapter contains instructions for action to be taken in connection with the initialstart.W ARNINGRisk of injury!If the control system is not fitted properly, the machine could move uncontrollably. Themachine’s engine shall not be started before the control system is completely fitted andits signals are verified.Starting the control systemStart the control system as follows:• Prior to start, all modules and cables are to be fitted correctly.• Check fuses, i.e. make sure that the supply voltage to the modules is equipped withthe correct fuse.• Make sure that connections for supply voltage and return lines are correct in thecable’s conductor joint.• Make sure an emergency stop is installed.The emergency stop should disconnect the supply voltage to all modules. Alterna-tively, the emergency stop may also shut off the diesel engine or a dump valve, andwith that, depressurize the hydraulic system.Prepare for system startW ARNINGMake sure no one is in dangerous proximity to the vehicle to avoidinjuries when it starts.Prepare for the initial system start as follows:• The engine for the hydraulic system’s pump shall be in off position.• Make sure that all connectors are properly connected.• Turn on the control system.• Make sure that voltage is being supplied to all modules; the power/status diode shallbe illuminated on all modules. Also, make sure that the master is in contact with allmodules by reading the master’s display.• Make sure the emergency stop is functioning properly.Start the systemStart the system as follows:• Start the engine for the hydraulic system’s pump, assuming that the above men-tioned inspections have been carried out and shown correct values.Calibrate and adjust input and output signals according to the instructions related to themaster menu system and check each and every output function carefully.