7AC30 Series LINKnet Product Manual HA474739U001Ethernet Recommendations:The PLC should be set up for Point To Point (Unicast) connection instead of Multicastconnection. If Multicast is used, a managed switch is recommended / required.The LINKnet module should be in a LAN / VLAN with only other equipment associatedwith its operation. Broadcast traffic on the LAN / VLAN should be kept to a minimum.Web Page:The AC30 Series LINKnet drive does not support a webpage.Communication differences:When using Ethernet communication to access drive parameters, the protocol foraccessing these parameters is different when using the LINKnet platform. When usingthe Codesys platform, parameters could be accessed directly via Modbus registers. Inthe LINKnet platform, parameters must be configured using the software tool DSE.
