Parker OSP-L Operating Instructions Manual

24Guides OSP-LØ63Ø25 to Ø5015 Assembly Instructions15.1 Slideline(SL25 / SL32 / SL40 / SL50 / SL63)For fitting and removal of the guide system the complete cylinder unit should be removed from the machineor plant.SL25 – SL32 – SL40 – SL50 SL63Dismantling of the Guide Carriage• Depressurise the cylinder and switch off all electrical power supply.• Remove all parts mounted externally on the guide carriage (11).• Unscrew one drive block (16) from piston of OSP, so that the guide carriage can be moved.• For the OSP-L40, OSP-L50 and OSP-L63 only: unscrew one end cap from the cylinder.• Loosen screws (6) on wiper cover (17).• Slide the complete guide carriage off the guide rail.• Unscrew wiper cover (7) (or 17+18 for SL63) from both ends of the guide carriage (11).• Inspect the parts – replace damaged or worn parts such as: wiper (9), slide profile (10) and felt (8)(service kit).Dismantling and Reassembly of the Guide Rail• To dismantle the guide rail (1) remove the screws (4) with their washers (3). Remove the guide rail (1)and clamping rail (2) from the cylinder profile.• Clean all the parts.• Centre the guide rail on the cylinder profile.• Fit the clamping rail (2) to the guide rail (1) and screw in the screws (4) with their washers (3)(use the specified torque).Reassembly of the Guide Carriage• Clean all the parts.• Grease the felts (8) with guide grease (Order No. 10550FIL).• Lay the wipers (9) or (21+22) and felts (8) in the wiper covers. The sealing lipof the wiper must be outwards (see drawing).• Back off the adjusting screws (14) in the guide carriage.• Lay in the support strip (5) on the same side as the adjusting screws.• Place 2 slide profiles (10) per side in the guide carriage.The edges of the slide profiles in which grooves are cut (to allow grease fromthe grease nipples to get to the guide rail) must touch each other.• Screw on the two wiper covers (7) or (17+18) loosely with the screws (6).Remounting the Reassembled Guide Carriage on the Guide Rail• Push the complete guide carriage assembly carefully onto the guide rail with the side with the adjustingscrews towards the piston.• If necessary move the felt wiper carefully into its correct position with a screwdriver.