Parker PSUP Series Installation Manual

Introduction PSUP Mains module8 192-120147N9 PSUP Manual 2019-061.4.3. Special safety instructionsCaution!Due to movable machine parts and high voltages, the device can pose a lethaldanger. Danger of electric shock in the case of non-respect of the followinginstructions. The device corresponds to DIN EN 61800-3, i.e. it is subject tolimited sale. The device can emit disturbances in certain local environments. Inthis case, the user is liable to take suitable measures. Check that all live terminals are secured against contact. Perilous voltage levelsof up to 850V occur. Do not bypass power direct currentCaution!Due to movable machine parts and high voltages, the device can pose a lethaldanger. Danger of electric shock in the case of non-respect of the followinginstructions. The device corresponds to DIN EN 61800-3, i.e. it is subject tolimited sale. The device can emit disturbances in certain local environments. Inthis case, the user is liable to take suitable measures. The device must be permanently grounded due to high earth leakage currents. The drive motor must be grounded with a suitable protective lead. The devices are equipped with high voltage DC condensers. Before removing theprotective cover, the discharging time must be awaited. After switching off thesupply voltage, it may take up to 10 minutes (with additional capacity modules itmay take up to 30 minutes) to discharge the capacitors.Danger of electric shock in case of non respect. Before you can work on the device, the supply voltage must be switched off at theL1, L2 and L3 clamps. Wait at least 10 minutes so that the power direct currentmay sink to a secure value (<50V). Check with the aid of a voltmeter, if thevoltage at the DC+ and DC- clamps has fallen to a value below 50V.Danger of electric shock in case of non respect. Do never perform resistance tests with elevated voltages (over 690V) on thewiring without separating the circuit to be tested from the drive. Please exchange devices only in currentless state and, in an axis system, only ina defined original state. If the axis controller is replaced, it is absolutely necessary to transfer theconfiguration determining the correct operation of the drive to the device, beforethe device is put into operation. Depending on the operation mode, a machinezero run will be necessary. The device contains electrostatically sensitive components. Please heed theelectrostatic protection measures while working at/with the device as well asduring installation and maintenance. Operation of the PSUP30 only with line choke.Attention - hot surface!The heat dissipater can reach very high temperatures (>70°C)