Paton StandardMIG-160 Data Sheet And Operating Manual

Paton StandardMIG-160 Data Sheet And Operating Manual Manual pdf 27 page image

-27 - PATON StandardMIG MMA/TIG/MIG/MAGAttention! If button 5 is being held for more than 10 seconds, then the countdown333 ... 222 ... 111 ... appears on the display, and you need to release the buttonbefore this time has elapsed in order not to reset all settings of this mode tostandard factory settings. This task will be considered in Clause 6.3.Similarly, when you press button 10, the graphic name of the current functionof the wire‐feeding machine is displayed on the digital indicator on the right side.Using buttons 12, you can change it to a smaller or larger side.If the menu is locked, as is the case with the function menu on the source, it isenough to hold this button for more than 3.5 seconds.6.2 SWITCHING TO THE REQUIRED WELDING MODEPress button 6 to select the desired welding mode. The modes switch overend‐around; it can be seen from lamps 4 on the front panel.6.3 RESET OF ALL FUNCTIONS SETTINGS FOR THE CURRENT WELDINGMODEThere can be situations when the user becomes confused with the machinesettings. In order to reset them to standard factory values, just hold button 5continuously for more than 10 seconds. The countdown 333... 222... 111... appearson the display, and upon reaching “000”, all settings of the current welding modewill be updated to the factory settings. In order to reset all the settings of themachine, you need to do this operation for each mode separately; this is done forconvenience, so as not to reset the second two modes, previously individuallyconfigured by the user.7. GENERAL LIST AND SEQUENCE OF FUNCTIONSMMA welding mode0) [-1-] – main displayed parameter CURRENT = 90A (by default)a) 8 ... 160А (increment 1А) for StandardMIG-160b) 10 ... 200А (increment 1А) for StandardMIG -200c) 12 ... 250А (increment 1А) for StandardMIG -2501) [H.St] Hot Start power = 40% (by default)a) 0[OFF] ... 100% (increment 1%)2) [t.HS] Hot Start time = 0.3 s (by default)a) 0.1 ... 1.0s (increment 0.1s)3) [Ar.F] Arc Force power = 40% (by default)a) 0[OFF] ... 100% (increment 1%)