How Drop and Insert works 140Access Server Administrators’ Reference Guide 10 • Drop and InsertOriginating Link (dractLinkIndex)Which WAN link this call originated on.Originating Channel (dractChannel)Which channel this call originated on.Passed to Link (dractPassLinkIndex)Which link this call was passed to.Passed to Channel (dractPassChannel)Which channel this call was passed to.Number Dialed (dractNumberDialed)The phone number that was used to dialed into the server (if this service is available from the exchange).Calling Number (dractCallingPhone)The phone number that was dialed from (if this service is available from the exchange).Session Time (dractSessionTime)The amount of time this call was/is active.Remaining Time (dractRemainingSession)The amount of time remaining in this session.State (dractState)Indicates current call progress.• setup(1)—Idle state waiting for call to be attached• alerting(2)—Channel is being alerted for transfer of call connecting on other WAN link• flash(3)—An incoming and outgoing call are contending for the same channel• online(4)—Call is actively being transferred through remote access server• sessiontime(5)—Call is transitioning to down state• clearForward(6)—Call is transitioning to down state• clearBackward(7)—Call is transitioning to down state• dead(8)—Call is disconnected• kill(9)—Call is disconnected by administratorHow Drop and Insert worksThe Telco informs the RAS that a call is inbound on a specific channel. If the desired function for that channelis set for dropInsert then the RAS will redirect the call out another WAN port (see figure 58). In effect, it looksas if the RAS is not there.
