Introduction 155Access Server Administrators’ Reference Guide 12 • EthernetIntroductionThe access server provides management and statistical information in the Ethernet window (see figure 66).Detailed information regarding the SNMP MIB II variables may be downloaded from RFC 1643, Definitionsof Managed Objects for the Ethernet-like Interface Types.Click on Ethernet under the Configuration Menu to display the Ethernet main window.The Ethernet main window displays information about the configuration of the Ethernet interface including IPaddresses, subnet masks, and state of the Ethernet link.The ethernet interface contains the following links:• Statistics link—Clicking on the Statistics link takes you to the page where you can see the statistics on theethernet interface. For more information about the Statistics page, refer to “Ethernet Statistics” onpage 158.• Modify—Clicking on the Modify link takes you to the page where you can change the configuration of yourethernet interface. For more information about modifying Ethernet settings, refer to “Ethernet ModifyWindow” on page 157.Figure 64. Ethernet Main WindowEthernet Main WindowThe Ethernet main window shows the current configuration of the ethernet interface. The following sectionsdescribe each parameter.State (boxEtherAState)Indicates the state of the ethernet interface. The following states are valid:• notInstalled(0)—Ethernet interface is not installed in the hardware• noLinkIndication(1)—The link is in the “down” state• adminOff(2)—The link is administratively down• linkIndication10M(3)—The link is up and running at 10M half duplex• linkIndication10Duplex(4)—The link is up and running at 10M full duplex• linkIndication100M(5)—The link is up and running at 100M half duplex• linkIndication100Duplex(6)—The link is up and running at 100M full duplex
