Patton electronics SmartNode 4900 Getting Started Manual

Also see for SMARTNODE 4900: User manual Quick start guide

Contents

Patton electronics SmartNode 4900 Getting Started Manual Manual pdf 29 page image

Installing the IpChannel Bank 29SmartNode 4900 Series Getting Started Guide 3 • Hardware installation6. Secure the IpChannel Bank in position with the mounting screws.7. Go to section “Connecting cables” on page 29Connecting cablesThis section describes installing the interface, power, and ground cables in the following order:1. Installing the RJ-11 voice port (FXS or FXO) cable or cables (see section “Connecting the FXS ports” onpage 29 or “Connecting the FXO ports” on page 29)2. Installing the 10/100 Ethernet port cable (see section “Connecting the Ethernet ports” on page 30)3. Installing the RS-232 console cable (see section “Connecting the EIA-561 RS-232 configuration port(DCE configured)” on page 31)4. Installing the V.35 or X.21 serial WAN cable (see section “Connecting the serial port” on page 31)5. Installing the power input (see section “Connecting to an external power source” on page 32)Connecting the FXS portsThe remote FXO devices are connected to the IpChannel Bank via the RJ-21X cable. Consult Appendix C onpage 60 in order to connect the FXO devices to the selected FXS port on the IpChannel Bank.1. Connect the RJ-21X connector of the cable into the 64-pin or 50-pin RJ-21X receptacle on the IpChannelBank. The pin count will depend on the IpChannel Bank that you ordered.2. The other end of the cable has 25 non-terminated twisted-pairs for connection to punch-down blocks.Select the twisted-pairs which will be used for3. Select and attach the appropriate twisted-pair from each FXO device on punch-down blocks for connec-tion to the chosen port on the IpChannel Bank.Connecting the FXO portsThe remote FXS devices are connected to the IpChannel Bank via the RJ-21X cable. Consult Appendix C onpage 60 in order to connect the FXS devices to the selected FXO port on the IpChannel Bank.1. Connect the RJ-21X connector of the cable into the 64-pin or 50-pin RJ-21X receptacle on the IpChannelBank. The pin count will depend on the IpChannel Bank that you ordered.2. The other end of the cable has 25 non-terminated twisted-pairs for connection to punch-down blocks.Select the twisted-pairs which will be used forThe Interconnecting cables must be acceptable for external useand must be rated for the proper application with respect to volt-age, current, anticipated temperature, flammability, andmechanical serviceability.Do not work on the system or connect or disconnect cables during periods oflightning activity.CAUTIONWARNINGVoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030