Patton electronics SmartNode 4900 Getting Started Manual

Also see for SMARTNODE 4900: User manual Quick start guide

Contents

Patton electronics SmartNode 4900 Getting Started Manual Manual pdf 43 page image

Bootloader 43SmartNode 4900 Series Getting Started Guide 4 • Getting started with the SmartNode 4900 SeriesStart-up with factory configurationLoad a new application image (SmartWare) via TFTPThe following procedure downloads the application image (SmartWare) for the mainboard. See the note belowon how to download the respective CLI description file.Step Command Purpose1 RedBoot> fis load Copies the SmartWare application image from thepersistent memory (flash:) to the volatile memory(RAM) from where it will be executed.2 RedBoot> go -s factory-config Starts the SmartWare application telling it to use‘factory-config’ as startup configuration.You can also start-up with any other configurationavailable in the persistent memory (nvram:) by pro-viding its name instead of ‘factory-config’.Step Command Purpose1optionalRedBoot> ip_address - llocal_ip_address [/mask_len]Sets the IP address and subnet mask of theEthernet interface 0/0 which shall be used toreceive the new application image.mask_len is the length of the network address(or the number of 1’s within the subnet mask).See Note below.2optionalRedBoot> ip_address -ggateway Sets the IP address of the default gateway.3optionalRedBoot> ping -htftp-server_ip_address Tests the connectivity to the TFTP server.4 RedBoot> load -r -v -hhost -bbase_address file_nameDownloads an application image into the vola-tile memory (RAM) from where the SmartNodecould directly execute it.host: IP address of the TFTP serverbase_address: memory location where to storethe application image. Use the default address0x1800100file_name: path and name of the file on theTFTP server. Note: use the image file that con-tains the whole application, not the imageparts.5 RedBoot> fis delete -n 1 Deletes the first application image.Reply with ‘y’ to the confirmation request.6 RedBoot> fis create Stores the downloaded application image tothe permanent memory (flash:).Reply with ‘y’ to the confirmation request.7 RedBoot> fis list -l Checks whether the image has been success-fully stored, whether it is the desired Releaseand Build, and whether it is valid.VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030