Philips 4000 Series User Manual

Also see for 4000 series: Quick start guide User manual Quick start guide Service manual Quick start guide

98BDL4650D50(4). Port: The port number for the FTP server is available inthe range from 1025 to 65535, the default setting is 2121.The following port number cannot be used:8000 / 9988 / 15220 / 28123 / 28124 and SICP networkport (default 5000).Finally, manually reboot the system to apply the FTP settings.Remote ControlSettings -> Signage Display -> Server Settings -> RemoteControlClick the checkbox “Enable” to enable or disable the remotecontrol client service. The default setting is “Enabled”. To usethe remote control feature, the device must be bound withthe remote control server.In the entry field of “Server”, input the URL address withthe prefix of “https://”. If the device is not bound with theremote control server, please enter the PIN code provided bythe server.Bind status:(1). If the device does not have an appropriate networkconnection, a message “Network is disconnected” willappear.(2). If the device is equipped with a network function,but is not connected to the remote control server, amessage “Server is disconnected” will appear.(3). If a server is connected, but not bound, a message“Server is unbinded” will appear.(4). If the device is bound with the server successfully, amessage “Server is binded” will appear.(5). If the PIN code is not correct, a message “Error PINcode” will appear.SNMPEnable/Disable the SNMP service.Please refer to the SNMP user manual.ADB over NetworkYou can access ADB over a network connection with port5555.