Philips 5000 Series User Manual

Also see for Essence 5000 Series: Quick start guide User manual Manual User manual Quick start guide

Satellite (if available)About Installing SatellitesUp to 4 SatellitesYou can install up to 4 satellites (4 LNBs) on this TV.Select the exact number of satellites you wish toinstall at the start of the installation. This will speed upthe installation.UnicableYou can use a Unicable system to connect theantenna dish to the TV. You can select Unicable for 1or for 2 satellites at the start of the installation.MDU - Multi-Dwelling-UnitThe built-in satellite tuners support MDU on the Astrasatellites and for Digiturk on the Eutelsat satellite.MDU on Türksat is not supported.Start the InstallationUpdate Channels (Home) > Settings > Satelliteinstalllation > Search for satellite > UpdatechannelsYou can always start a channel update manually, newchannels will be added, and unavailable channels willbe removed.Enter PIN code if necessary.Re-install Channels (Home) > Settings > Satelliteinstalllation > Search for satellite > Re-installchannelsYou can search satellites and channels againmanually.1. Select one option you need to re-install.2. Select Settings or select Start to update channels.Settings MenuPress  Reset to reset, or press  Done whencomplete the settings.- Connection typeSelect the number of satellites you want to install.The TV sets the appropriate connection typeautomatically.• Up to 4 Satellites - You can install up to 4 satellites(4 LNBs) on this TV. Select the exact number ofsatellites you wish to install at the start of theinstallation. This will speed up the installation.• Unicable - You can use a Unicable system toconnect the antenna dish to the TV. You can selectUnicable for 1 or for 2 satellites at the start of theinstallation.- LNB settingsIn some countries, you can adjust the expert settingsfor homing transponder and each LNB. Only use orchange these settings when a normal installation fails.If you have non-standard satellite equipment, youcan use these settings to overrule the standardsettings. Some providers might give you sometransponder or LNB valeus which you can enter here.• LNB Power - By default, LNB Power is set to On.• 22 kHz Tone - By default, the Tone is set to Auto.• Low LO Frequency / High LO Frequency - The localoscillator frequencies are set to standard values.Adjust the values only in case of exceptionalequipment that needs different values.Enter PIN code if necessary.Add Satellite or Remove Satellite (Home) > Settings > Satelliteinstalllation > Search for satellite > Add satelliteor Remove satellite (Home) > Settings > Satelliteinstalllation > Search for satellite > Add satellite• You can add an additional satellite to your currentsatellite installation. The installed satellites and theirchannels remain untouched. Some satellite operatorsdo not allow adding a satellite.• The additional satellite should be seen as an extra, itis not your main satellite subscription or not the mainsatellite of which you use its channel package.Typically, you would add a 4th satellite when youhave 3 satellites already installed. If you have 4satellites installed, you might consider removing onefirst to be able to add a new satellite.• If you currently have only 1 or 2 satellites installed,the current installation settings might not allowadding an extra satellite. If you need to change theinstallation settings, you must redo the completesatellite installation. You cannot use Add satellite ifa change of settings is needed. (Home) > Settings > Satelliteinstalllation > Search for satellite > RemovesatelliteYou can remove one or more satellites from yourcurrent satellite installation. You remove the satelliteand its channels. Some satellite operators do notallow removing a satellite.26