Philips HD7862/21 User Manual

Also see for HD7862/20: Service manual

2 Press the on/off button 3. (Fig. 9), The light in the on/off button flashes slowly while the water heats up. Heatingup takes approx. 75 seconds., The coffee machine is ready for use when the light in the on/off button lightsup continuously.Note: If the water reservoir does not contain enough water to brew one cup ofSENSEO® coffee, the light in the on/off button flashes rapidly and the 1-cup and 2-cupbuttons cannot be operated.3 Move the lid release lever upwards and open the lid (Fig. 4).4 Place the appropriate pod holder in the machine.Note: Make sure the pod holder is clean and the sieve in the centre is not clogged, e.g.with loose coffee grains.- If you want to make one cup of SENSEO® coffee, use 1 coffee pod incombination with the 1-cup pod holder q and the 1-cup button q. (Fig. 10)- If you want to make two cups of SENSEO ® coffee, use 2 coffee pods incombination with the deeper 2-cup pod holder qq and press the 2-cup buttonqq. (Fig. 11)5 Place the SENSEO® coffee pod or pods properly in the centre of the podholder with the convex side pointing downwards.Note: Use SENSEO® coffee pods from Douwe Egberts especially designed for yourSENSEO® coffee machine for a full and round taste.- Place 1 SENSEO® coffee pod in the 1-cup pod holder q. (Fig. 12)- Place 2 SENSEO ® coffee pods in the 2-cup pod holder qq. (Fig. 13)Note: Make sure the coffee in the pod or pods is evenly distributed and press the pod orpods lightly into the pod holder.Never put normal ground coffee or use torn pods in the machine, as this causes itto become blocked.6 Close the lid and lock the lever (Fig. 14).Make sure you push down the lid lever until it snaps home with a click.Note: It is not possible to brew coffee when the lid is not properly closed and the lid leveris not locked.7 To adjust the drip tray to the size of the cups you want to use, first detachthe drip tray by sliding it slightly upwards (1) and then pulling it towards you(2) (Fig. 15).8 To reattach the drip tray, push it against the front of the machine at therequired height (1). Make sure the top of the back plate of the drip tray is onone line with one set of guide lines. Then slide the drip tray slightly downwards(2) to make its hooks slip into the slots.9 Place one or two cups on the cup tray.Tip:The cups you use should have a capacity of at least 150ml. Do not use cups that aretoo large, as they cause the coffee to get cold more quickly.10 Select the desired coffee strength by moving the strength selection slide up ordown. (Fig. 16)- Select ) for a small cup (60ml) of strong coffee.- Select ( for a normal cup (125ml) of coffee.11 Press the 1-cup button q if you want to brew 1 cup. Press the 2-cup buttonqq if you want to brew 2 cups. (Fig. 17), The SENSEO® coffee machine starts brewing. The machine automaticallysupplies the optimal amount of water.Note:You can interrupt the brewing process at any time by pressing the on/off button3. If you switch the machine back on after having interrupted the brewing process, themachine does not complete the interrupted brewing cycle.Do not remove the water reservoir during a brewing cycle, as this causes themachine to draw in air. When this happens, the machine only partly fills the nextcup.12 Lift the pod holder out of the machine and remove the coffee pod or pods.Note: Be careful when you do this, for there may still be some hot water or coffee on thecoffee pod or pods.Tips- To make sure the coffee always tastes optimally, rinse the pod holders, the coffeecollector and the coffee spout regularly.- The SENSEO ® coffee tastes best if you stir it before you drink it.- If you intend to make another cup of SENSEO ® coffee later, just leave the coffeemachine switched on. The machine automatically switches itself off after 30minutes.CleaningNever immerse the SENSEO® coffee machine in water.Never use scouring pads, abrasive cleaning agents or aggressive liquids such aspetrol or acetone to clean the machine.Never clean the machine by flushing it with the lid open.Note: All detachable parts are dishwasher-proof.1 Unplug the machine.2 Clean the outside of the machine with a soft moist cloth.Remove stubborn coffee stains with vinegar diluted with hot water and then wipeaway the vinegar residues with a soft cloth moistened with clean water.3 Remove the coffee spout from the machine. (Fig. 18)4 Remove the coffee spout cover from the coffee spout (Fig. 19).5 Remove the decorative spout cover (Fig. 20).6 Remove the coffee collector (Fig. 21).7 Clean the coffee spout, the coffee spout cover, the decorative spout cover,the coffee collector, the pod holders, the cup tray and the drip tray in thedishwasher or in hot water with some washing-up liquid (Fig. 22).Note: If you clean the cup tray by hand, always remove it from the machine and holdit in your hand, as it might prove sharp when it is handled incorrectly. Always handle itcarefully (Fig. 23).Note: After you have cleaned the pod holders, check if the sieve in the centre is clogged.If this is the case, unclog the sieve by rinsing the pod holders under a running tap. Use awashing-up brush to clean the sieve, if necessary (Fig. 24).8 Clean the water reservoir in hot water, if necessary with some washing-upliquid.You can also clean the water reservoir in the dishwasher. (Fig. 25)Note: If you use a washing-up brush, be careful not to damage the valve in the bottom ofthe water tank.Tip:You can remove the anti-splash rim of the water reservoir to clean the insidethoroughly.9 Do not use an object with sharp edges to clean the water inlet on themachine (Fig. 26).10 Rinse the parts with fresh water after cleaning and put them back into themachine.11 Clean the water distribution disc with a moist cloth (Fig. 27).Be careful when you do this; make sure that the rubber sealing ring does notget stuck under the edge of the water distribution disc. If it does, the coffeemachine starts leaking.FlushingIf you have not used the coffee machine for three days, flush it with fresh waterbefore you use it again.Flush the machine in the following way:1 Fill the water reservoir with cold water up to the MAX indication and put itback into the machine. (Fig. 3)2 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machinewithout pod or pods.3 Put a bowl (with a capacity of at least 1500ml) under the coffee spout tocollect the water. (Fig. 7)Note: Make sure the bowl is placed stably on the drip tray or the foot of the machineto prevent it from wobbling or toppling over during the flushing cycle.You can also usea square or rectangular container.4 Press the on/off button 3 (1) and then press the 1-cup button q and the2-cup button qq briefly at the same time (2). (Fig. 8)The machine fills itself quickly with water from the water reservoir. It starts to flushimmediately and switches itself off after the flushing cycle.DescalingWhen to descaleDescale the SENSEO® coffee machine frequently! Preferably descale 4 to 6 times ayear, but at least once every 3 months. Descaling takes about 1 hour.Why to descaleScale builds up inside the appliance during use. It is essential to descale the SENSEO®coffee machine at least every 3 months. Your reasons to descale:- It prolongs the life of your SENSEO ® coffee machine- It ensures maximum cup volume- It ensures maximum coffee temperature- The machine produces less sound during brewing- It prevents malfunctioningIf the descaling procedure is not performed correctly, scale residue remains behindin the machine. This causes scale to build up more quickly and may cause permanentand irreparable damage to the machine.Use the correct descaling agentNever use a descaling agent based on mineral acids such as sulphuric acid,hydrochloric acid, sulphamic acid and acetic acid (e.g. vinegar). These descalingagents may damage your SENSEO® coffee machine.Only citric acid-based descalers are suitable for descaling the SENSEO ® machine. Thistype of descaler descales the appliance without damaging it. For the correct amount,34222.200.0483.1