Philips Saeco PicoBaristo SM5479 User Manual

11 The second phase of the descaling cycle, the rinsing phase, starts and lasts 3 minutes. The displayshows the rinsing icon and the duration of the phase.12 Wait until the machine stops dispensing water. The descaling procedure is finished when the tickappears on the display.13 Press the OK button to exit the descaling cycle. The machine starts heating up and performs theautomatic rinsing cycle.14 Clean the milk carafe after descaling (see 'Weekly cleaning of the milk carafe').15 Clean the brew group after descaling (see 'Cleaning the brew group under the tap').16 Place a new AquaClean filter in the water tank.Tip: Using the AquaClean filter reduces the need for descaling!What to do if the descaling procedure is interruptedYou can exit the descaling procedure by pressing the on/off button on the control panel. If thedescaling procedure is interrupted before it is completely finished, do the following:1 Empty and rinse the water tank thoroughly.2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machineback on. The machine will heat up and perform an automatic rinsing cycle.3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, firstdispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without addingground coffee.Note: If the descaling procedure was not completed, the machine will require another descalingprocedure as soon as possible.Warning icons and error codesMeaning of the warning iconsMeaning of the warning iconsThe warning icons are displayed in red. Below you find a list of the warning icons that may appear onthe display and their meaning.ADD WATERFill the water tank with freshwater to the MAX levelindication. INSERT CARAFEThe milk carafe is not installed.Insert the milk carafe into themachine.ADD COFFEEThe bean hopper is empty.Put new coffee beans in thebean hopper.The coffee grounds containeris full. Make sure the machineis switched on. Then removeand empty the coffee groundscontainer.The brew group is not in themachine or it is not insertedcorrectly. Insert the brewgroup.The brew group is blocked bycoffee powder. Clean the brewgroup.16 English