Philips Saeco PicoBaristo SM5479 User Manual

INSERTWATER SPOUTThe hot water dispensingspout is not installed. Insertthe hot water dispensingspout.Insert the drip tray and closethe service door.10SUPPORT REQUIREDIf the display shows an errorcode, check section 'Meaningof the error codes' to seewhat the code on the displaymeans and what you can do.The machine cannot be usedwhen this icon is on thedisplay.Insert hot water spout andpress OK button to start.Meaning of error codesBelow you find a list of the error codes showing problems that you can solve yourself. Videoinstructions are available on www.saeco.com/care. If another error code appears, please contact thePhilips Consumer Care Center in your country. For contact details, see the warranty leaflet.ErrorcodeProblem Possible solution01 The coffee funnel isclogged.Switch off the machine and unplug it. Remove the brew group.Then open the lid of the pre-ground coffee compartment andinsert the spoon handle. Move the handle up and down untilthe clogged ground coffee falls down (Fig. 20). Visitwww.saeco.com/care for detailed video instructions.03 The brew group is dirtyor not well-greased.Switch off the machine with the main switch. Rinse the brewgroup with fresh water, let it air-dry and then lubricate it.Consult chapter 'Cleaning the brew group' or visitwww.saeco.com/care for detailed video instructions. Thenswitch the machine on again.04 The brew group is notpositioned correctly.Switch off the machine with the main switch. Remove the brewgroup and reinsert it. Make sure that the brew group is in thecorrect position before you insert it. Consult chapter 'Handlingthe brew group or visit www.saeco.com/care for detailedvideo instructions. Then switch the machine on again.05 There is air in the watercircuit.Restart the machine by switching it off and on again with themain switch. If this works, dispense 2-3 cups of hot water.Descale the machine if you have not done so for a longerperiod of time.The AquaClean filterwas not preparedproperly beforeinstallation or it isclogged.Remove the AquaClean filter and try again to brew a coffee. Ifthis works, make sure that the AquaClean filter is preparedproperly before you place it back (see 'Preparing theAquaClean filter for activation'). Put the AquaClean filter backinto the water tank. If this still does not work, the filter isclogged and needs to be replaced.14 The machine isoverheated.Switch the machine off and switch it back on again after 30minutes.17English