Q-See Q4DVR4RCM User Manual

Contents

Q-See Q4DVR4RCM User Manual Manual pdf 10 page image

5.14Hard Disk SetupPOWREMonitorUP DATA+DATAMENUDOWNDigital video Recoder Monitor4 DualPAL NTSCIf you choose YES, recordingcontinues and overwrite previous recording when hard diskdrive space is full.If you choose NO, the recording session stops when allhard disk drive is full for recording.It shows the size of the primaryhard disk drive installed in the DVR.OVERWRITE ENABLED:MASTER HDD SIZE:..............................................................................................................................It shows the space used on the first hard disk drive forrecording and the percent Of the used hard disk.If you format the hard drive, it will erase all the datarecorded on the first hard disk drive.It shows the space the secondary hard disk drive installed in theDVR.It shows the space used on the primary hard disk drive forrecording.If you format the hard drive, it will erase all the data recordedon the secondary hard disk drive.MASTER HDD USED:MASTER HDD FORMAT:Notice: when you first use a HDD in the DVR, please use this function to formatthe HDD. Otherwise the computer will not find the HDD when you connect the DVRto the computer by using the USB cableSLAVE HDD SIZE:SLAVE HDD USED:SLAVE HDD FORMAT:................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................5.15 Alarm SetupPOWREMonitorUP DATA+DATAMENUDOWNDigital video Recoder Monitor4 DualPAL NTSCALARM SETUPALARM RECORD DURATION 10ALARM DURATION OFFBUZZER DURATION OFFSENSOR SETUPMOTION SETUPPRESS(UP,DOWN). THEN(SELECT)PRESS(MENU) TO EXITAlarm Record Duration:Alarm Duration:Buzzer Duration:Sensor Setup:The number indicates how longtriggered recording lasts after the sensors are triggered orthe movements in front of the camera.It controls how long (in seconds) thealarm lasts after the system is triggered.Buzzer time set (OFF 05 10 1520 25 30 seconds and CONT) , User can press[ SEL/EDIT ] to set the time .When Buzzer Time is OFF ,All the buzzers will be shut off. When Buzzers Time isCONT ,the buzzer will work continuously.There are 3 different modes for sensor setting: NOTINSTALLED, NORMAL-CLOSE and NORMAL-OPEN.It depends on what type of external sensor you use. Ifsensor's output is NORMAL-OPEN then select NORMAL-OPEN mode in DVR.If sensor triggered by an intruder then the cable lineconnects to DVR input terminal will notify system to startrecording.There are four pairs of input terminal supported by DVR...............................................................................................................................................................................................................................................................................POWREMonitorUP DATA+DATAMENUDOWNDigital video Recoder Monitor4 DualPAL NTSCSENSOR SETUPCHANNEL-1 NOT INSTALLED TYPE: NORMAL-OPENCHANNEL-2 NOT INSTALLED TYPE: NORMAL-OPENCHANNEL-3 NOT INSTALLED TYPE: NORMAL-OPENCHANNEL-4 NOT INSTALLED TYPE: NORMAL-OPENPRESS(UP,DOWN). THEN(SELECT)PRESS(MENU) TO EXIT<2 3 41RS485RS485 SENSORSENSOR ALARMALARMPush the UNLOCK BUTTON above the wire hole to insertor pull out a wire.9