Q-See Q4DVR4RCM User Manual

Contents

Q-See Q4DVR4RCM User Manual Manual pdf 7 page image

DVR Setup5.DVR Setup5.1 Main MenuPress[ MENU] to enter MAIN MENU, use [ UP] and[ DOWN] to select item, press [ SEL/EDIT] to modifysetting and [ MENU] to confirm and exit......................POWREMonitorUP DATA+DATAMENUDOWNDigital video Recoder Monitor4 DualPAL NTSCMenu DirectoryMain MenuCamera SelectRecord SelectRecord ModeRecord Frame RateVideo QualityRecord ScheduleSub MenuHard Disk SetupAlarm SetupRestore Factory Default5.2 Camera SelectYour DVR can display 4 cameras on one screen (QuadMode). You can configure which camera(s) to display.Press [ SEL/EDIT] to change the setting or press[ CH1] [ CH2] [ CH3] [ CH4] to set eachchannel separately. If a channel is not used, the systemwill display OFF on the monitor for that channel.................POWREMonitorUP DATA+DATAMENUDOWNDigital video Recoder Monitor4 DualPAL NTSC8%OFF OFFOFF OFF1 23 42008/08/08 08:08:08Auto RecodePassword SetupPassword ChangePicture SetupTime SetupPTZ Setup5.3 Record Select5.4 Record ModeConfigure which channel is allowed to record.Each Mode Compress and record each channel video separately, therefore, usercan enlarge single channel video to full screen display. For example,user can turn off record function of CH~1 and CH~2 and then systemonly record CH3 and CH4 video.Press[ CH1], [ CH2], [ CH3], [ CH4] to switch channel todisplay when playback recorded video.Only in this mode, when system is in watching mode or recording mode,press [ QUAD] button over 3 seconds to make each channel videoenlarge to full screen and then display in quad mode in sequence again.....................................................................................................6