Q-See QC40198 User Manual
Also see for QC40196: User manualQuick installation guideQuick installation guide
                                    | |
Contents
| 
52 53CHAPTER 6 PAN/TILT/ZOOM CAMERASCONTROLSelecting the Pan/Tilt/Zoom shortcut will open the Pan/Tilt/Zoom controls windowSpeed – From 1 to 8and adjust zoom, focus and irisUsing the mouse, you can control thedirection of the camera’s movements byclicking on the arrows.Intelligent Positioning Key - If your protocol supports it, clicking and dragging in the bluebutton in the center will allow you to move the camera faster – between 4 to 16xspeed.SETTING PRESET/PATROL/PATTERN/SCANClicking the Set button in the PTZ Control Panel (Picture 6-5) opens a new window inaddition to leaving the PTZ Control Panel active.PICTURE 6-5PICTURE 6-6PICTURE 6-7This window allows you to set up the PTZ’sPreset, Tour, Pattern and Border functions.PresetSTEP 1. Start by using the eight direction arrows on the PTZ Control Panel (Picture 6-5)to position the camera where you want.STEP 2. Click the Preset button in the Function list and enter the number you want toassign to this preset.This preset can now be added to a tour.PatrolSTEP 1. Click the Patrol button in theFunction list and enter the number ofthe preset you wish to add to it.STEP 2. Click Add Preset to enter itinto the tour. You can have up to 80presets in a single patrol.STEP 3. Assign the patrol a numberPatternSTEP 1. Click the Pattern button in theFunction list.STEP 2. Click the Begin buttonSTEP 3. Modify the zoom focus andiris settings using the PTZ ControlPanel (Picture 6-5)STEP 4. Click the End button to save thechangesSTEP 5. Enter the desired number forthis pattern into the field.Border (Auto Scan)STEP 1. Click the Border button in theFunction listSTEP 2. Select either the Left or Rightbutton to indicate which edge you aredefiningSTEP 3. Use the direction arrows in thePTZ Control Panel (Picture 6-5) tomove the camera to the limit desired.STEP 4. Repeat for the other border.PICTURE 6-8PICTURE 6-9In the PTZ Control Panel (Picture 6-5), clicking the PTZ Trace button will begin the autoscan. The button will convert to a Stop button which can be used to end the scan.PICTURE 6-10 |
Related manuals for Q-See QC40196
manualsdatabase
Your AI-powered manual search engine