QCT QuantaGrid Series Service Manual

Also see for QuantaGrid Series: User guide

Contents

Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
intended application uses
Connectors
about the system
Introduction
specifications
Package Contents
A Tour of the System
Mainboard
System Front View
System Rear View
PSU View
LED Definitions
BMC Management Port LED
Safety Measures
Power Supply Unit
Installing the Power Supply Unit
HDD Tray
Securing a HDD Tray
Hot-plug HDD
Removing a HDD carrier and HDD from the HDD tray
Installing a HDD carrier with HDD to HDD tray
Top Cover
Fan Module
Installing a Fan Module
Memory Modules
Installing a Memory Module
Processor Heat Sink
Processor
Installing the Processor
Expansion Card
Installing a Riser Assembly
OCP Mezzanine Board
Installing an OCP Mezzanine Board
BIOS Setup Utility
Keyboard Commands
Menu Selection Bar
Server Platform Setup Utility Screens
Advanced Screen
IntelRCSetup Screen
Server Management Screen
Boot Options Screen
Security Screen
Exit Screen
Loading BIOS Defaults
BIOS Update Utility
BIOS Setting Utility
BIOS Update Via BMC Instructions (Optional)
Server Management
Reset
Interface to Server Management (Optional)
Server Management Software
Front Panel User Interface
Session and User
BMC Firmware Update
Recovery Process in DOS System
SMASH
System Level Commands
BMC Information
Using the Web GUI
Dashboard
Device Information
Network Information
FRU Information
Server Component
Server identify
BIOS POST Code
Sensor Readings
Event Log
Configuration Group
LDAP/E-Directory
Mouse Mode
Network
RADIUS
Remote Session
SMTP
User Management
Virtual Media
SNMP
LAN Port Settings
Remote Control
Server Power Control
BIOS Update
Restore Factory Defaults
User Privilege

QCT QuantaGrid Series Service Manual Manual pdf 44 page image

I NSTALLING HARDWARE P ROCESSOR H EAT S INK2-192.8 Processor Heat SinkRemoving a Processor Heat Sink1. Remove the top cover.2. Loosen the captive screws securing the heat sink in a sequential order.Figure 2-18. Removing the Heat Sink3. Remove the heat sink.4. Repeat steps for the other heat sink.Installing a Processor Heat Sink1. Remove the top cover.2. Align the heat sink over the processor plate.Note:All the instructions and images in this section are for illustration purposes only and may notreflect the actual product.WARNING!The heatsink remains hot after the system has been powered down. Allow sufficient time tocool before handling system components.!

/ 167

This manual is suitable for:

QuantaGrid Series QuantaGrid D51PH-1ULH

manualsdatabase

Your AI-powered manual search engine