QERIDOO Sportrex1 User Manual
                   | |
28 – 02|2017 – Subject to change. Sportrex Sportrex Subject to change. – 02|2017 – 29Adjusting the tilt of the backrestFor the backrest you can set two tilt angles by moving its upper horizontal bar: 128 degrees: The horizontal bar is secured in the rear position.This tilt is pre-set at the factory and is recommended for carrying small children who may fallasleep during the journey. 115 degrees: The horizontal bar is secured in the front position.This more upright seating position is recommended for older children who participate activelyin the journey.Tip!Do not adjust the tilt during the journey as this can take some time.To adjust the tilting degree, you will need a size 4 hex key.f Release the backrest’s upper horizontal bar byremoving the screws on both sides.f Put the horizontal bar into its new position betweenthe cabin frame holes.f Insert the screws through the holes into the horizontal bar and tighten the screws securely.f Tension the harnesses on the rear of the cabin, see “Tightening the backrest” on page 16.StorageTo store the Sportrex, simply fold it up and keep it in a protected location. Pay attention also tothe instructions in the chapter “Care” on page 30.Danger!Hands or fingers can become trapped on moving parts while setting up and folding upthe cab. Carry out work carefully and keep children away from the vehicle.f Take position behind the cabin and open the storagespace cover.f Pull both sliders on the vertical cabin tubes all the wayup. This releases the lock on the rear frame rod.f Press the rear frame rod inwards.f Fold up the cabin by pressing both sides of the rearcabin frame all the way down.Caution!Only fold up the cabin after it has been cleaned both inside and outside and iscompletely dry.UtilisationUtilisation |
manualsdatabase
Your AI-powered manual search engine