QSC TouchMix-8 User Manual

Also see for TouchMix-16: User guide Technical notes User manual Self-Guided Tour Quick start guides

Contents

QSC TouchMix-8 User Manual Manual pdf 42 page image

34TD-000472-00-BInput Channel – FX SendsControls how much of the Input channel’s audio is sent to the FX devices. In addition, you can adjust the FX Sends at Menu > FX Overview.Refer to — Figure 23 –1. FX Tab – Selects the FX Sends screen.2. FX Send Sliders – Sets the level of audio “sent” from the channel to the FX mix; -40 dBis off.3. FX Processor – The thumbnail representation of the FX processor takes you to a screenwhere you can select the processor for that FX mix.4. Simple FX – Hides the Global FX Parameters for a simpler setup.5. Nlobal FX Parameters – Provides control over the two most important parameters ofthe selected FX device. The controls are different depending on the selected processor.For detail on these and other FX controls, refer to the FX device topic.6. Pitch Correct – Refer to Input Channel – Pitch Correct on page 35.FX Signal FlowAudio input passes through the EQ, Dynamics (compressor and gate) and the ChannelFader. At this point the audio signal is split and goes in two directions:1. Through the Pan control to the Main L/R Fader and Main outputs.2. To the 4 Channel FX sends (Figure 6 shows just one of the four FX Sends)The FX Send control determines how much of the channel audio is sent (or routed) to the assigned FX processor.The FX processor works its magic on the audio and transforms the mono input into a stereo signal. The FX Master fader controls how much or howlittle of the processed (“wet”) signal is combined with the unprocessed (“dry”) before going to the FX Master fader and on to the Main L/R outputs.— Figure 24 —InputChannels-40 -20 -10 -5 5 10UEQ DynamicsChannelFaderChannelPanFXSendsAudioInputL C RFXMasterMainL/RFXMainLeftMainRightHome Select anInput BankTouch SelectButtonSelectFX TabFXIn 2Inputs 1-8— Figure 23 —213456