+7(495) 797-3311 www.qtech.ruМосква, Новозаводская ул., 18, стр. 115Chapter 2 Basic Switch Configuration2.1 Basic ConfigurationBasic switch configuration includes commands for entering and exiting the admin mode,commands for entering and exiting interface mode, for configuring and displaying the switchclock, for displaying the version information of the switch system, etc.Command ExplanationNormal User Mode/ Admin Modeenable [<1-15>]disableThe User uses enable command to step into admin modefrom normal user mode or modify the privilege level of theusers. The disable command is for exiting admin mode.Admin Modeconfig [terminal] Enter global mode from admin mode.Various ModesexitExit current mode and enter previous mode, such as usingthis command in global mode to go back to admin mode, andback to normal user mode from admin mode.show privilege Show privilege of the current users.Except User Mode/ Admin Modeend Quit current mode and return to Admin mode when not atUser Mode/ Admin Mode.Admin Modeclock set [YYYY.MM.DD] Set system date and time.show version Display version information of the switch.set default Restore to the factory default.write Save current configuration parameters to Flash Memory.reload Hot reset the switch.show cpu usage Show CPU usage rate.show cpu utilization Show current CPU utilization rate.show memory usage Show memory usage rate.Global Modebanner motd no banner motdConfigure the information displayed when the loginauthentication of a telnet or console user is successful.
