Qlogic SANbox 5000 Series Interface Manual

Also see for SANbox 5000 Series: Reference guide Reference guide Brochure Installation guide Installation guide

Contents

Qlogic SANbox 5000 Series Interface Manual Manual pdf 128 page image

12 – Call Home ConfigurationCall Home Concepts12-2 59183-02 AS12.1.1Call Home RequirementsIn addition to enabling the Call Home service, you must also do the following toensure that email messages can be sent: Configure the Call Home service. The Call Home service configurationconsists of primary and secondary SMTP server specifications and contactinformation. You must enable and specify an address and service port for atleast one SMTP server. Refer to “Configuring the Call Home Service” onpage 12-5. Configure the Call Home database The Call Home database consists of upto 25 Call Home profiles. Each profile defines the following: Event severity levels (Alarm, Critical, Warn) that will initiate an emailmessage Email message format and subject Email recipientsMultiple profiles make it possible to notify different audiences based on anycombination of event severity, message format (short or full), or messagelength. You configure profiles using the Profile command within a CallhomeEdit session. Refer to “Managing the Call Home Database” on page 12-6. Ensure that each switch that is to support Call Home email notification hasits own Ethernet connection.Enter the Callhome Test command to test your Call Home service and databaseconfigurations. Refer to “Testing a Call Home Profile” on page 12-12.