Quadra-Fire 31-I ACC Installation Manual

Also see for 31I-ACC: Installation manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

Quadra-Fire 31-I ACC Installation Manual Manual pdf 4 page image

4 7044-225B April 9, 201431-I ACCInstall Guide2 Getting StartedA. Design and Installation ConsiderationsBefore installing, determine the following:• Type of chimney connector to be used· single wall, 6 inch (152mm) diameter, stainless steel, or· double wall, 6 inch (152mm) diameter, stainless steel• Consult page 28 for clearances to combustibles• Power outlet located close by for optional blowerDraft is the pressure difference needed to vent appliancessuccessfully. When a appliance is drafting successfully, allcombustion byproducts are exiting the home through thechimney.Considerations for successful draft include:• Preventing negative pressure• Location of appliance and chimneyTo be sure that your appliance burns properly:• During a low burn, the chimney draft (static pressure) shouldbe approximately -.04 inch water column (W.C.)• During a high burn the chimney draft should be approximately-.10 inch (W.C.)• Measure the W.C at 6 inches (152mm) above the top of theappliance after one hour of operation at each burn setting.B. DraftCheck building codes prior to installation.• Installation MUST comply with local, regional, state andnational codes and regulations.• Consult insurance carrier, local building, fire officials orauthorities having jurisdiction about restrictions, installationinspection, and permits.CAUTIONWARNING• DO NOT CONNECT THIS UNIT TO A CHIMNEYFLUE SERVICING ANOTHER APPLIANCE.• DO NOT CONNECT TO ANY AIR DISTRIBUTIONDUCT OR SYSTEM.May allow flue gases to enter the house.Asphyxiation Risk.• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part not approvedby Hearth & Home Technologies.• Operating appliance without fully assembling all components.• Operating appliance without legs attached (if supplied withunit).• Do NOT Overfire - If appliance or chimney connector glows,you are overfiring.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will bevoided by, the following actions:NOTICE: Hearth & Home Technologies assumes noresponsibility for the improper performance of theappliance system caused by:• Inadequate draft due to environmental conditions• Downdrafts• Tight sealing construction of the structure• Mechanical exhausting devices• Overdrafting caused by excessive chimney heights• Ideal performance is with height of chimney between14-16 feet (4.26-4.88m) measured from the base ofthe appliance.