Quadra-Fire 31I-ACC Owner's Manual

Contents

Quadra-Fire 31I-ACC Owner's Manual Manual pdf 40 page image

Page 40 7044-140B February 10, 2010R3100-I ACC Wood InsertF. Surround & Trim Kit Installation1. Lay surround face down on a protected surface to pre-vent scratching.2. Using a Phillips head screw driver attach the side sur-rounds to the top surround using 2 #8 sheet metal screwsprovided with the kit. Figure 40.4.. Lay the trim face down and place the corner brackets intoposition.4. Using a standard flat screw driver tighten the cornerbrackets. Figure 40.5.5. Slide the trim over the surround set.6. Install the surround set and trim set to the outer can.Secure the top and side surrounds as shown in Figure40.6Secure 2 Side Surrounds toTop SurroundAttachment Holes to Outer CanFigure 40.4Corner BracketsFigure 40.5Top SurroundSide Surround# 8 ScrewsFigure 40.6E. Installing Outer Can & Leveling Bolts1. Align the back of surface of outer can side panels to thefront wall surface for proper placement. Figure 40.2.Use the leveling bolts to level the outer can. Figure 40.1.. Thread the horizontal support bolts in until they hit theback wall of the fireplace to help secure in place. Figure40.3.4. It is recommended that you use the pallet mounting holesto lag the outer can into the fireplace floor for extra sup-port, however it is not required.HorizontalSupport BoltsLeveling BoltsOuter Can Side PanelsWallWallWallOuter CanSide PanelFigure 40.1Figure 40.2HorizontalSupport BoltsBack WallFigure 40.3