Page 6 7044-140B February 10, 2010R3100-I ACC Wood Insert1 Listing and Code ApprovalsThe Quadra-Fire 100 Wood Insert (ACC) meets the U.S.Environmental Protection Agency’s 1990 particulate emis-sion standards.A. Appliance CertificationC. Glass SpecificationsD. BTU & Efficiency SpecificationsThis stove is equipped with 5mm ceramic glass. Replaceglass only with 5mm ceramic glass. Please contact yourdealer for replacement glass.B. Mobile Home ApprovedEPA Certified: 2.0 grams per hourEfficiency: up to 79.66%BTU Output: 11,800 to 2,000Heating Capacity: up to 1800 sq ft dependingon climate zoneVent Size: 6 inchesFirebox Size: 2 cubic feetMax Wood Length: 18 inchesFuel: Cord WoodShipping Weight: 45 lbsModel: 100-I (ACC) InsertLaboratory: OMNI Test Laboratories, Inc.Report No: 061-S-74-, 061-S-74-6.2Type: Solid Fuel Type, Listed Room HeaterStandard: UL1482 and ULC S628-9 and(UM) 84-HUD, Mobile HomeApproved.NOTE: Hearth & Home Technologies, manufacturer ofthis appliance, reserves the right to alter its products,their specifications and/or price without notice.NOTE: This installation must conform with local codes. In theabsence of local codes you must comply with the UL1482,(UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S628-9 and CAN/CSA-B65 Installation Codes in Canada.• This appliance is approved for mobile home installationswhen not installed in a sleeping room and when an out-side combustion air inlet is provided.• The structural integrity of the mobile home floor, ceiling,and walls must be maintained.• The appliance must be properly grounded to the frameof the mobile home with #8 copper ground wire, and useonly listed double-wall connector pipe.• Outside Air Kit, part OAK-ACC must be installed in a mo-bile home installation.Improper installation, adjustment, alteration, service ormaintenance can cause injury or property damage.For assistance or additional information, consult a qualifiedinstaller, service agency or your dealer.Quadra-Fire is a registered trademark of Hearth & HomeTechnologies.• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part not approvedby Hearth & Home Technologies.• Operating appliance without fully assembling allcomponents.• Operating appliance without legs attached (if supplied withunit).• Do NOT Overfire - If appliance or chimney connector glows,you are overfiring.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will bevoided by, the following actions: